HOW DO I REMOVE A JVC KDS25 FRON THE DASH - JVC Car Audio & Video

Unbolt the master cylinder from the booster, then unbolt the booster from the firewall, removing the vacuum line from the booster also. hanging the pedals, you need to remove a keeper fron the pivot bar under dash that the pedals hang from. Then push the pivot pin out to drop the pedals.

Do you want to replace your old chicago forge 12"? You can get a replacement from where you bought the old one. If it's not under warranty, prepare the bucks for it.

does your radio still have the lil metal clip things if so slide that in between your radio and the lil metal surround and it should click then just pull out other wise you have to remove the dash kit

These are the keys used for pulling out the set from the in dash mountings. hence is you have sold the carrs it will be useful for theparty to remove the set from the dash. However this is available with most of the service centres. This will not have any use to you but for any JVC car audio customer. Hope you find the buyer. Good day

why instead you try connect to dvd RECORDR and make a dvd on it then finalize it on it and play it where ever you want. I did it. It works perfectly for me and more convienient with space on dvd and there is no need for software. Good luck

Hi,

The same can be found on the flowing thread;

http://audio.manualsonline.com/manuals/mfg/jvc/kds25.html

Please let us know if that was helpful enough.

Good Luck & Thanks,
Shiv.

hi could you let me know the model number as most manuals can be downloaded fron the net

1.disconect the neg. fron battery.
2.the blower unit is located under the dash and behind the glove box.
3.open the glove box disconnect the cord.push inwardson the sides to lower the door fully.
4.remove the dash panel to the right (has one screw)
5.remove the inner frame scrrews (four screws)
6.remove the blower/evaporator mounting bolts and remove blower motor.
7.tranfer the fan to new motor prior to installation.
8.installationis the reverse of removal.
f.y.i. use pliers to release and remove the clip holdin blower fan to th emotor

today's in-dash cd players are a 2 part mounting system. One part is the carrier chassis that is hard mounted to the dash. Then the cd player slides into part 1 and latches. To remove player from part 1, insert 2 long and narrow metal tools along each side to un-latch the player. The tools come with a new unit. To make these, try making them out of 1/16 inch thick metal and trimming to following dimensions: 6 inches long by 1/2 inch wide and at one end, narrow down to about 1/8 inch about 1 inch from the end. deburr all edges. This 2 part system is designed for anti-theft defense.

No Manual with it? See if there is a download fron the JVC web site.