I need the part on the top that steadys it
SOURCE: i have an apache 3 channel helicopter.the top
Same problem I had. There are two motors. One to spin the top blade and a second to spin the bottom. My motor was defective out of the box to spin the top blade. Very poor quality as my AH 64 had a bad circuit board. I had to take parts from one to fix the other.
SOURCE: New 27 MHZ Helicopter Controller won't turn on
I have a 27Mhz helicoper (looks identical to the one on the picture). I tried to fly it for the first time, but I am having problems controlling it. The left radio control lever sends the helicopter upwards, but the right hand control doesn't seem to do anything and that should make it go backwards and forwards. Can anyone help me as well please?
SOURCE: how to synchronize a Hawk talon V3 radio control
If it has 3 channles then you turn the helicopter on first, then turn the remote on. If its not a 3 channle helicopter i dont know sorry.
SOURCE: My son's mini air hawk
I found your question while searching the web for parts for my son's new, broken Air Hawk II. I also found that there are a few different mini helis marketed as "Air Hawk", so I'm not sure that my answer will apply to your machine. Mine came in a box as shown here: http://www.toygalaxy.net/2chmirche.html
OUR problem, which might be your problem too, is that the cylindrical metal weights flew off the ends of the stabilizer bar at the top of the heli. First, one came off, which threw the heli out of balance, which caused a violent shaking that probably helped the other weight to fly off. Without the weights, the stabilizer can't do its job, and the heli sways. Our temporary fix was to cut two strips of duct tape, 3/4" x 1.5" each, and wrap one strip around the outer 3/4" of each end of the stabilizer bar. This made our heli fly almost as well as it did when brand new.
The heli pictured here is almost identical to ours, and has the same weights on the stabilizer bar - these photos show what our SB looked like before the weights flew off... http://www.dhgate.com/2ch-rc-helicopter-air-wolf-co-axle-rtf-palm/k-ff808081278edf340127988dde3b153d-0.html#todescription
Hope this helps... happy flying (we can wish, right?)
SOURCE: I recently purchased a Fast
I have the same one, i have searched long and hard for parts for this without much sucsess, allthough i have found this on ebay, the blades and rotor look very simular
http://www.ebay.co.uk/itm/Metal-3-Ch-RC-Mini-Helicopter-Main-Tail-Blade-SET-G-/140315300745
Its slightly diffrent but i think the blades should fit the hawk 4. In the mean time i shall keep looking.
1,866 views
Usually answered in minutes!
×