Hover Lites RAdio-Controlled Helicopter

Mine broke and i have no idea what parts to buy!

it spins uncontrolably

I bought this helicopter and it broke in the same spot while in flight. The counter weight just flew off and down it came. I tried both web sites with the same results.

The main rotor blade broke along with the counterweight and connector piece after a moderately rough landing. The importer says they no longer carry the product and can't help me with parts.

The antenns broke off at the tip and Blue hat did list 2 different web sites which neither one is real?? Looking for a replacement part.

Just purchased a Hover LIte heli at CVS July 23, 2008 . I took the product out of the box and grabed hold of the Rotor Assembly and it broke in my hand . I looked over the Rotor Assembly and noticed 2 (Two) small air pockets in the plastic. It Broke straight across them . What a bummer....

no parts, no service, two fights and i didnt even crash it broke the main rotor where the screw is for the bal..............
****

My roter blade broke at the center turn buckle. It looks like there was a small air bubble in the plastic mold, I was wondering if this part was available? I have done some internet searching, the store I bought the unit from is somewhat of a clearance house and I don't believe they will take the product back. Thank You - Kelly

main rotor broken after accident

Try this link for parts. Not sure if they are the same but most look like they fit.
http://www.raidentech.com/sy90drrchesp.html
Maybe one of the others will fit. Haven't broken my yet but would be nice to find parts.

To fix the tail rotor problem is the little white gear is installed the wrong way. Slip it off and reverse it. Looks like a rice grain.
Make sure the antenna wire (RED) is hooked to the little screw.
Make sure the rotors and the small black thing on top of the rotor are very free. Should just be able to flip and they come back to even. If free but unlevel use a piece of tape to balance. Check all screws to make sure that they are tight. Mine had almost all screws loose to barely holding the screw in.
Just bought one today and my buddy help get it going. He has 3 and learned the hard way. The Cockpit holder is not straight normaly but there is a screw you can pull it our and do some bending and make it right.

Hope this helps to make most of your problems go away.

Ron

I have EXACTLY the same problem with a Hoverlites by: Blue Hat Toy Company. Actually I have TWO of them. The blade holder assembly broke in half on one side at the place where the blade screws on. The result is a blade broken off and no way to repair it. I can't help but notice that at the time of this writing 88 other people have REPORTED exactly the same problem. It makes you wonder how many MORE copters there are out there that are defective and are NOT reported. This toy obviously has a serious problem. I HAVE TWO OF THEM!!

the connection with the main rotor blade and the center rod snaped on a hard landing.
I tryed to cement it back together with jb weld. tryed to crazy glue it.and thats it.
I want to know what i can do to get this fixed, or were i can go to get it fixed.

the conection with the main blade and the center rod broke

New in the box, HAW, cockpit housing scratch, it looks like it was already crashed. Nuts missing from wire that connects frame to the tail. first hard landing the piece that connects the two rotor blades broke. super glue won't even hold it together. I'm very disappointed in the product.

I bought a copter from Rite Aid and I lost the connect buckle third flying session. Can't find a new one so I bought another Hover Lite for spare parts. Now I can't another.
Lewey

Bought this for our grandson...need replacement parts...can't locate
them on line. don't know where to go for this...Pat

i have bought one from ebay it was supposed tobe new but it was missing the two wings on the rear bar like to find parts for it
thank you

I need spare parts too. A balance bar for the Hover Lite Helicopter.

Please email me.

Thanks, Falene

My wife gave me a Hover LIte for Christmas. On the 1st flight I had no tailrotor control. tried to make a running landing, but the thing wouldn't slipstream. Ended up with a busted tailboom where it bolts to the main frame of the aircraft.

The main rotor system works but the tail rotor doesn't. I have checked the wiring from the receiver to the tail motor and it is OK. The tail motor is also OK. My grandson got this as a present from his grand uncle in Maryland and on it's first trial it spiraled into the air and crashed. Most of the damage is repairable except the main rotor blade connector. It broke in half. I can replace it if I can get a new one. The tail rotor problem appears to be either the transmitter or the receiver electronics (circuit board). This unit is a 27 band unit. Thanks for any help. LeRoy Reeves 9856 Crestwood Dr. Twinsburg, Ohio 44087

My son received the Hover Lites Helicopter for Xmas and today 3/26/08 was the first day with minimal wind we could try it out. We flew it twice and on the 2nd run when it landed the tail rudder broke off. I was able to glue it, but I dont know how long it will last. Where the tail rudder ties into the main frame of helicopter is truly a poor design. I am sure from the reading about others with the same product and having the same problem my glueing solution will probably not last.

Pete

Every link I have found for parts so far is bogus

The long tail section just behind the body of the helicopter was broken when we took the helicopter out of the box. We have never had the opportunity to fly the helicopter because of this. We need a replacement for this part.

Nancy Scott
nancys@johndaugherty.com

I have found parts on ebay

need tail rotor blade

We didn't even get a first flight; the tail rotor broke x-mas morning upon pre-flight testing and pot adjustment.
Seems as though this company got their money; no contact and/or replacement parts information included in the manual.
It might have cost about a dollar less profit to have included a couple of repair parts with the product. This would have at the least shown an effort in producing a viable product. I'm sure that a few minutes of testing would have shown which components were problematic.
Looks like we all got burned ! !
Thanks Innovage LLC

Need the tail rotor blade cannot find one

I cannot find the triangle shaped connector that attaches the blades to the main rotor of the Hover Lite, where can I find them?

cant the find the blade that makes the helicopter fly up and down
where can i find parts for this i already checked ebay contact me at my email address eells68@myway.com thank you

Brocken 19 inch rotor blade

cannot find company for replacement plastic tail mount for my hover lite helicopter. looked on-line for blue hat with no luck.help! My son flew it one time only. Treid fixing myself but still spins uncontrollably...Brian

Connectors connecting stabilizer blade (drive shaft for main rotor) to main rotor blade broke within hours of initial operation. Need extra connectors. Tried to repair using thread but thread keeps breaking.

My son broke the AC/DC Adaptor for my HoverLite Helicopter. Where can I source a replacement part?

I have a hover lite helicopter. The assembly that holds the main rotor blades is broken on one side and one blade can not be reattached. need the main rotor assembly. The blades are ok. I have not been able to find parts any where.Ron

I have a hover lite and the assembly that holds the main blades has broken. so one blade is detatched and can not be reattached. need new assembly. Have not been able to find any parts.
Ron

We have cracked the sleve that the bar (holding the tail fin & tail motor) slides into just under the main motor. This piece that cracked has wiring routed through a hole in this piece. This wiring goes from the circuit board into the tail fin and motor bar. Without a solid piece the tail fin bar will slide out and fall off during flight.

need what seems like a simple part to fix the rotorblade

Helicopter spun in circles , when I adjusted the potentiometer to correct on lift off it start to rise the started spinning, on inspection the plastic screw in the potentiometer had come out/broke. Need new potentiometer.

need main rotor bkade holder.
Rhea

I finally was able to contact this God awful company and promptly blown off with "empty" promises of replacement parts. They only had some of them. They proceeded to yell at me about not using the toy correctly. I told them that a helicptor of a suggested retail price of $99.95 certainly should have held up better which they quickly changed the subject. The people that answer the phone are totally rude and you must demand to speak to a supervisor which grudgingly answer your questions. I suggested for them to check this web site to see what people are saying. Here is the phone number for them 949 587-9207. Good luck

Broken connector arm between main and secondary rotors. Sounds like it's impossoble to get replacement parts

broken tail rotor, need replacement part

Where can I get parts?

Broke the little dog bone that attaches the main rotor blades to the mast

Where can we find new parts for4 Hoverlites Radio-controlled helicopter. Was flying second flight after adjusting tail rotor, got about 50 feet in the air and the main rotor stopped turning. At that point the helicopter fell to the ground and the cockpit broke in half, the battery housing broke half the way off, and one of the main rotors broke off along with the connect buckle. where can we get these parts..

Jacob

dwpcafp@aol.com

I crashed and broke plastic parts between main rotor blade and stabilizer blade. The model was the Sky Scrambler as well. Got it for a Christmas gift and within three hours it was falling apart and unuseable.

I NEED A MAIN ROTOR BLADE AND STABILIZER FOR THE HOVER LITE RC HELICOPTER

Tail propeller broke after day 2 of flying the toy helicopter. Where can I order a new one?

need replacement parts that join the main blades together. broke after one flight

broken tail rotor

Need parts

I'm looking for parts for my Blue Hat Toy Co. Hoverlite. Any information please email me at: mefoto@ix.netcom.com

My son just received his 1st hoverlites from uncle in california; we live in louisiana. On his first day to fly, it flipped over and the rotor blade broke. Looking to see if it can be replaced. if so, let me know something at mablanco1@bellsouth.net .

First flight and it crashed and broke the rotator blades. Where can we find a requirement.

need parts

need a new balance bar

hover lite radio controlled helicopter

I also need parts such as battery holder and main rotor attachment!
Bill

1st time out we broke the balance bar and the main rotor blades.

large blade broke off af connection. i'm looking for replacement parts.

Same problem here...the Sky Scrambler is just a piece of junk. My son is so disappointed. Broke it once, returned to store for replacement, immediately it broke again.

I have already sent this message once. Fixya is not a fix. Please help me find these parts. hooverlites helicopter between the roater blades and the stabiler blade.
pb

I just brought one for xmas and it crashed and burned. I can't find whom to call about this problem. I tried innovage LLC and there isn't anyone in at the office all day..

i need a balance bar for a hover lites helicopter

broken part need replacement balance bar or to be able to order part form the company

braken balance bar need replacement part and I can not any way to contact the company blue hat toy company

hover lite parts

the shaft extending to the tail rotor has broken.

We have purchased a HoverLite RC Helicoptor and can only keep it charged for approximately 8-10 minutes. Is this a common problem with this toy or is there a fault with this particular toy?

manuellmiguel@clearwire.net

i need spare parts such as rotor blades

Got this for a Christmas gift for my son. After 2 min. or less of flying time, it
crashed. Broke balancing bar and tail rotor. How do you get replacement parts?




gerrydavis61@yahoo.com

Had my hoverLite for 5 min. and I broke main rotor mount for big blades ...Help

I've flown helicopter for about 15 min and had a hard landing and tail rotor broke in half Where do I find spare parts for this helicopter?? It is the Blue Hat Toy Company Wireless Indoor helicopter.Can't find anything on line to get parts.Thanks

richardsr23@hotmail.com

The main roter blade connection broke the first time we flue it.We are looking for a replacement part !! It is easy enough to take apart. But we need to know how to get the part...

I have a Hover lites helicopter and need a new balance bar this allso made by BLUE HAT toy company.
lrrr_@yahoo.com

Does anyone know where to find replacement parts for the HoverLites Helicopter? The balance bar broke and needs to be replaced.

Replacement parts are for my children's Skyscambler-Wireless Indoor Helicoper needed. Where can I get them? Please send info to davidkathy1@bellsouth.net
146 Sioux Lane
Opelousas, LA 70570-0327

looking for the same replacement parts, please conact Dave if you have answer: skigate6@comcst.net

My maiden flight of my HoverLite ended with my tail rotor blade snapping in half. I would live to order a new one but it didn't come with an order sheet or even a website to contact.

crashed two of these helicopters also need parts

Is there anywhere I can get parts for the hoverlites helicoper

First flight up was great, but the first landing broke the balance bar into two pieces and the peg that holds the cockpit in place also into two pieces. Can't find the part in the grass where it crashed. Help me find parts. chetvacey@yahoo.com

sky scrambler tail rotor broke - won't work without one

Broke main blades, canot find any parts. I searched the internet for parts and found nothing!
sbaum@clearwire.net

My copter had a rough landing, and the cab broke in half along with the large blade as well as the battery harness, I need replacement parts, where can I get parts? Frank

i need rear rotor blade for toy helicopter.

I need rotor blades to be able to use the Hover Lites Radio Controlled Helicopter. I husband crashed it on the first time out and we would really like to see this work. Can you assist me in getting any rotor blades to fit the Hover Lites?

I have been to every small blade shop toy shop bicycle shop, you get the idea to fix this helicopter. Can you help with any where I might can find parts to get this thing flying?

Regards,
pbruce9581@charter.net

The "pot" (potentiometer) on my Hover Lite does not work.When I adjust the pot to stop the spinning it doesn't change a thing.I was going to put a meter on it but becouse it doesn't make any adjustment at all I thought a new pot would be better.Can you help me find a new potentiometer?

Need AC Adapter. Any suggestions?

Rich

I cant find parts

plastic rotor head broken. Glue. Did not work.

main rotor blade flew off and busted before i even got it airborn

I need replacement main rotor that holds large blades.

Crashed and in need of replacement parts (like the others). Would like to get flying again!

Thanks, Joe C.

covelli.5@sbcglobal.net

Broke shaft extending out to tail rotor

need parts for main rotor

I crashed and broke plastic parts between main rotor blade and stabilizer blade. I would like to know if there are any replcement parts available. The modle is the Sky Scrambler.
thanx Brett

WHERE CAN I GET REPLACEMENT PARTS?

JIM

jboucher@depatie.com