Question about Whirlpool GI6FDRXXY

1 Answer

I HAVE A WHIRLPOOL MODEL GI6FDRXXY 07, AND THE EVAPORADOR MOTOR DOESNOT WORKING... IT NO RECEIVE THE 12 V... WHY? A NEED A WIRING DIAGRAM... TO CHECK...

I HAVE CHECK DE MOTOR AND IS GOOD... BUT NOT RECEIVE THE 12V... AND THE REFREGERATOR DOESNOT WORKING WELL..

Posted by on

  • ADOLFO OSORIO
    ADOLFO OSORIO Feb 22, 2015

    Thanks, i just bought and replaced it, now i am waiting for the correct operation of refrigerator... however, i would like to take the wiring diagrams... of this.

  • You should be getting 120 volts to the motor. If your are not it is probably a problem on the control card. or a wire connection loose or cut. If you have a multimeter you can easily check the voltage port where the evaporator fan plugs into the control board.

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 187 Answers

If your evaporator motor is not working, you are so correct. The air circulated in the refrigerator is due to the evaporator motor fan. If left to operate without a fan to provide a heat load for your compressor, it could cause your compressor to fail. Your problem is most likely the defrost sensor inside the cover of your evaporator. It is probably stuck open and will not put power to your evaporator fan. Take you model number to Searspartsdirect.com and find the defrost sensor for your refrigerator and replace it.
Hope this helps

Posted on Dec 14, 2014

Testimonial: "Thanks, now i have replaced the evaporator fan motor and temperature sensor and the defrost sensor... but the freezer is not cold enough... what can i do? i see that the evaporator fan not working yet.... the refrigerator is working well."

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I wire a Coleman Evcon 3500A916 furnace Model


Wiring Diagram for a Coleman Furnace - RV-Coach Online

www.rv-coach.com > Discussion Forum > RV - Insurance
... Furnace, Mark, 9-12-07. Need wiring diagram for coleman furnace Model # 7700B856 .... Amanda, 11-10-11. I need a wiring diagram for a Coleman evconpresidential model 7956c856 ... Need wireing diagram for coleman 3500a916 ... More results from www.rv-coach.com

FURNACE Diagram & Parts List for Model eb15b Coleman ...


Dec 22, 2015 | Coleman Heating & Cooling

1 Answer

RADIO HAS NO POWER


It can be faulty radio amp or radio control fuse is blown out.Check voltage at radio wires.You should get 12 volts.

For more help on car radio problems, I suggest you to go through these troubleshooting links, these will help you: -----

Click the link below: ---

-----

Cigarette lighter, Remote central locking, and Radio stopped working

http://whoisbyme.blogspot.in/2012/07/cigarette-lighter-remote-central.html

-------

VW passat radio off safe mode? VW radio CODE?

http://schematicsdiagram.blogspot.in/2012/03/vw-passat-radio-off-safe-mode-vw-radio.html

-------------

How to wire new Radio on 1990 Toyota Celica?

http://schematicsdiagram.blogspot.com/2011/12/how-to-wire-new-radio-on-1990-toyota.html

--------------

Radio Stereo Wiring Diagram for 1991 Chevy 1500?

http://schematicsdiagram.blogspot.com/2011/12/radio-stereo-wiring-diagram-for-1991.html

------------------

How to remove radio on Acura Car models?

http://repairhelpcenter.blogspot.com/2011/11/how-to-remove-radio-on-acura-car-models.html

---------------

Where is Radio Fuse located on 2007 Dodge charger?

http://schematicsdiagram.blogspot.com/2011/12/where-is-radio-fuse-located-on-2007.html

-------------

How to reset Radio code after car battery is died?

http://howtobyme.blogspot.com/2011/12/how-to-reset-radio-code-after-car.html

-------------

Can car radio code block Passkey anti theft system ?

http://schematicsdiagram.blogspot.com/2011/12/can-car-radio-code-block-passkey-anti.html


----------

After Market Stereo wiring for 1999 Chevrolet Silverado 1500?

http://schematicsdiagram.blogspot.com/2011/12/after-market-stereo-wiring-for-1999.html

---------

Chevy car radio doesn't allow to switch to the XM Band to get the radio ID?

http://schematicsdiagram.blogspot.com/2012/01/chevy-car-radio-doesnt-allow-to-switch.html

-------

No power to radio on 2005 Toyota Scion Xb?

http://repairhelpcenter.blogspot.com/2012/01/no-power-to-radio-on-2005-toyota-scion.html

---------

Lexus rx330 Radio has power but no sound?

http://repairhelpcenter.blogspot.com/2012/01/lexus-rx330-radio-has-power-but-no.html

-------

Radio goes ON and OFF while driving?

http://technoanswers.blogspot.com/2012/01/radio-goes-on-and-off-while-driving.html

------

Lincoln Town Car Radio stereo wiring?

http://technoanswers.blogspot.in/2012/02/lincoln-town-car-radio-stereo-wiring.html

------

Radio wiring diagram for 1997 Lincoln Town Car?

http://technoanswers.blogspot.in/2012/02/radio-wiring-diagram-for-1997-lincoln.html

----

How to remove cd player from dash on 2003 Lincoln Aviator

http://technoanswers.blogspot.in/2012/01/how-to-remove-cd-player-from-dash-on.html

----------

These details will help you thanks.

Dec 25, 2012 | 1998 Saturn SL

1 Answer

Service light flashing + error code f 07 on whirlpool washing machine


Motor control unit (MCU) error
The Central Control Unit has detected a short in the motor control unit. If a failure occurs during high-speed spin the door will be unlocked after 3 minutes.
  • Check wire harness connections between the Drive Motor and the Motor Control Unit (MCU)
  • Check wiring between the MCU and the Central Control Unit (CCU)
  • Check the MCU
  • Check the Drive Motor
  • Check the Wire Harness

Dec 23, 2012 | Whirlpool Washing Machines

1 Answer

Deli drawer hinge broke


Try searching w/ Google on the brand and model no.

Here's one possibility: Parts

Sep 01, 2012 | Whirlpool GI6FDRXXY

1 Answer

Need wiring diagram for pioneer deh-6300ub


Installation instructions and wiring diagrams begin on page 12 of the manual.

Jul 15, 2012 | Pioneer DEH-6300ub CD Receiver with...

1 Answer

Agitator doesnot move, water will go into washer, agitator doesnot spin and water will not go out of washer. can this be repaired? Do I need to replace the washer?


This assumes that you have a basic Kenmore / Whirlpool top load, direct drive, neutral drain (it doesn't spin until the pump
removes most of the water) machine.

First, see the Sears parts site for your washer:
http://www.searspartsdirect.com/partsdirect/index.action

Enter your model number (110.#######) and you'll see a list of major sub-components with diagrams and parts.

Two possibilities:


Newer model Whirlpool / Kenmore washers use a Lid Switch as a safety device. Unless the switch senses that the lid on the washer is closed, the washer will neither agitate nor spin.

Older models only used the switch during the spin cycle.

Try to bypass the Lid Switch by removing the Console and jumping the two outermost pins on the switch.

This is a Whirlpool PDF on how these washers operate. It has a diagram on jumping the switch as well as a detailed section on how the transmission works.

https://secured.whirlpool.com/Service/SrvTechAdm.nsf/2cd44500d572193285256a45004fd9d6/f7e2147fa98b28cf85257122007475cb/$FILE/L-55.pdf


It also has a troubleshooting guide.

To bypass the switch, you only have to disconnect the power to the washer, tilt the console back, unplug the switch and using an short piece of insulated wire, jump the two outermost contacts on the connector coming from the console and plug the washer back in.

Following is a description of how to gain access to the console and how to remove the cabinet if necessary.

http://www.american-appliance.com/catalog/newsdesk_info.php?newsPath=16&newsdesk_id=131&osCsid=913ba652cd504fb162f87d892bcb427b

With the jumper in place, try to re-start the washer.

If it works, the Lid Switch is a relatively inexpensive part.

If the washer still doesn't work, check the motor coupler.

Kenmore / Whirlpool top load, direct drive washers use a "Motor Coupler" between the motor and transmission.

It's used as a fail safe device and consists of three parts.

Two of the parts are the same, plastic units with three prongs that fit on one of the motor output shafts and the other on the

transmission input shaft. Between them is a rubber piece with six holes.

The power from the motor is transmitted through the rubber piece to the transmission.

The other shaft on the motor directly drives the pump.

If the motor coupler is broken, or worn, the motor may not be able to send full power to the transmission for agitating or
spinning.

See the following for how to remove the cabinet, pump, motor and motor mounting plate to inspect and replace the motor coupler.

http://www.american-appliance.com/catalog/newsdesk_info.php?newsPath=16&newsdesk_id=135

If the coupler looks damaged, it's a relatively easy fix.

Pry the plastic pieces from the motor and transmission. Some people use a claw hammer but I've found that using a small (6 inch) pry bar works well.

Carefully fit the plastic pieces over the motor and transmission shafts and press them in place (Use a 1/2" of larger socket to put pressure equally around the pieces.

Put the rubber piece on the transmission plastic piece.

Replace the motor mounting plate.

Carefully line up the plastic prongs on the motor based plastic piece to the three un-used holes in the rubber piece. If they don't line up right, the coupler could be damaged.

Mount the motor, don't forget the two screws, put the pump back on the motor and use its' clips.

Put the cabinet back on, don't forget to plug the lid switch back in and re-mount the console.

If this is a basic top load, direct drive washer, luckily most mechanical parts are relatively easy to access and fix or replace. I'd hold off looking for a new washer until I checked the Lid Switch and Coupler. These are the two parts that tend to break on top load washers.

Aug 22, 2010 | Kenmore 24622 Top Load Washer

1 Answer

Multiplication table


x 01 02 03 04 05 06 07 08 09 ...
01 01 02 03 04 05 06 07 08 09 ...
02 02 04 06 08 10 12 14 16 18 ...
03 03 06 09 12 15 18 21 24 27 ...
04 04 08 12 16 20 24 28 32 36 ...
05 05 10 15 20 25 30 35 40 45 ...
06 06 12 18 24 30 36 42 48 54 ...
07 07 14 21 28 35 42 49 56 63 ...
08 08 16 24 32 40 48 56 64 72 ...
09 09 18 27 36 45 54 63 72 81 ...
... ... ... ... ... ... ... ... ... ... ...

Jun 15, 2010 | Mathematical Technologies Inc. MTI Tristan...

1 Answer

I need to know how to wire the motor on a kenmore belt driven washer----i.e. which wires go to which as the plugs on the end of the wires were removed and know the spin does not work


First, see the Sears parts site for your washer:
http://www.searspartsdirect.com/partsdirect/index.action

Enter your model number and you'll see a list of major sub-components with diagrams and parts.

From there you may be able to get PDF files of manuals for your washer.

Since Whirlpool makes most of the Kenmore washers, see the whirlpool site that lists PDF's for many of their products.

https://secured.whirlpool.com/Service/SrvTechAdm.nsf/2cd44500d572193285256a45004fd9d6?OpenView&Start=1

Without a model number, it would be difficult to try to track down the wiring diagrams.

Sep 26, 2009 | Kenmore 24032\24036 Top Load Washer

Not finding what you are looking for?
Whirlpool GI6FDRXXY Logo

159 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Refrigerators Experts

John Tripp
John Tripp

Level 3 Expert

4654 Answers

Charles T Nevin
Charles T Nevin

Level 3 Expert

4066 Answers

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Are you a Whirlpool Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...