What is error e000532-0001 in canon c5250 ? - Canon Office Equipment & Supplies

Question edited for clarity and your French Typos.
Question translated to English.

This is a North American website and we only speak English.

All the answers are below and all in English

https://www.google.com/search?q=imageRUNNER+ADVANCE+C5250%3B+bootable+DL+project+error

Canon Support for imageRUNNER ADVANCE C5250

Canon USA https://www.usa.canon.com > Canon Support

Find support for your Canon imageRUNNER ADVANCE C5250. Browse the recommended drivers, downloads, and manuals to make sure your product ...

imageRUNNER ADVANCE C5250 - Support

Canon Central and North Africa https://en.canon-cna.com > support > products > imag...

Canon · Consumer Product Support · imageRUNNER Series Support - Download drivers, software, manuals. Product range. Canon imageRUNNER ADVANCE C5250. iR-ADV ...

Message will disaphear after waste bottle replacement..If not, clean waste toner sensor.

While the drum units may appear the same, chances are Okidata puts a different chip on it that makes in incompatible. The C5200 will use drums from a C5150. The C5250 appears to use different supplies.

Check the BK Drum, error says that the drum wont rotate with the correct speed. I had that before, i have had a sticker stuck to the drum unit.

post the error message here only then we can help

There are 2 entrances into the multi purpose tray. The one I needed access to opened from the sides and not the front (which opened the entire front cover). There was then a flap inside which allowed me to adjust the size of the documents to feed in, including envelopes, which the main tray doesn't.

Here is what you can try:

1. Turn off the power and unplug it from power source.
2. Open the right side of the printer (looking at the front).
3. Disconnect, by pulling gently, both white flat ribbon cables off the main circuit board.
4. Plug in the power source and turn the printer on. Wait till you get a error message and push "OK".
5. Unplug the power source.
6. Reconnect the flat ribbon cables by aligning and carefully pushing them into the conectors on the main circuit board.
7. Plug in the power source and turn the printer on (Printer preparing occurred).
8. The 0xc18a0306 error should now be gone.

http://www.fixya.com/support/t5587774-hp_photosmart_c5180_ink_system_failed

One of the colors might be out. Try replacing the color cartridge.

Here's the link; http://www.oki.co.uk/binaryData/10009/C5250uEN3.pdf and here is the product info page if you need more; http://www.oki.co.uk/fcgi-bin/public.fcgi?pid=118&cid=125&chid=10&pdflag=2&prid=534 Hope this helps :)