Where does the override key go In on 45891 I took paper off front and there is a circle disk we cannot get off any ideas? We can not open it the green light comes on but it won't turn

Hello, Richard -

The image here:
https://www.terapeak.com/worth/replacement-keys-manual-for-bunker-hill-electronic-digital-safe-model-45891/162049295398/
shows the keys for the Bunker Hill safe model 45981. The keys are in the center, lower part of the image.

The image of the front of a different model Bunker Hill safe from the owner's manual here:
https://www.manualagent.com/harbor-freight/0-19-cubic-ft-electronic-digital-safe/product-manual-2
shows here the key "slot" is located.

Best wishes.

2005 CTS 3.6 Dead battery, key stuck, service anti theft and nothing happens when you turn key, Ttried everything, ECM reset, key memory reset, charged battery to 12.7 volts, locked door w remote and opened w key, anyway you get the idea. After 3 days of online reading and trying, THIS IS WHAT WORKED, 1. put key into on position 2. removed sarter relay from front fuse panel 3. jumped 1st pin closest to fender and passenger seat with pin that is closest to motor and front fender. I used a paper clip and just made contact long enough for car to start. ran car for five minutes and took key out and everything went back to normal. then I took car to advance auto parts to have engine light reset. if car does not go back to normal you have ECM (car computer) failure. video on YouTube under "no crank, no start"

There is no override code. But maybe a override key the normal key is to open the bolt after the correct code is entered.
Cracked or drilled.
Call a locksmith to help.
Don't fall for the biggest add in the phone book a good locksmith could never afford a full page add and offer a good price.

Safe has Key lock hidden on it? Contact Harbor Freight with serial number, to try and get new key. Once opened follow these instructions at:

http://www.harborfreight.com/manuals/93000-93999/93575.pdf

there is red button on the inside of the door (hinge side) press this , then key in a new code

how do i change combination on bunker hill 45891 safe, i have tried every way i can think of.

Most manual overrides involved pressing and holding either the eject button or the power button on the machine itself (not the remote). Try those first.

If that doesn't work reply with the following info:
Will your system turn on/off?
Are you able to play the disk that's in the drawer?

Take the single screw off of the entry pad and remove the cover plate. Using the key that came with the safe, unlock the safe. Now, look for a little red button on the inner hinge. Push it in and you will note the yellow led on the the front of the safe turns on. Now, enter a 4 digit code of you choice. This is automatically saved and is the new 4 digit code you press to open the safe.

CHANGING CODE ON MODEL # 45891:
On the inside of the door toward the hinge, you will see a small red button. Press this button until the yellow light on the front control panel lights up. Now you can imput the new code (1 to 8 digits) into the front control panel, followed by either the "A" or "B" key. The safe will beep twice (2 times) to confirm the code has been changed. Important: If the safe beeps 3 times, then the code has not been accepted and you must repeat the above steps.
DO NOT LET THE BATTERIES RUN OUT BECAUSE YOU WILL NOT BE ABLE TO OPEN THE SAFE OR CHANGE BATTERIES.

What I did was took apart my Xbox and put the disc tray back on the tracks, carefully lifting it over the circle thing in the middle. When I lay my Box down horizontally, it opens and closes fine.