Question about Car Audio & Video

1 Answer

How do I set my crossover for my kicker zr360 for bass with two switched

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,249 Answers
Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 29 Answers

SOURCE: kicker zr360 amp

Double check that your ground wire is connected to the ground terminal, make sure the ground wire is not broken.

Posted on Nov 11, 2007

sumthin
  • 71 Answers

SOURCE: How do you set this stuff?

Need more info..
How many amps and their RMS rated power.?
If one amp, how many channels + individual power for each channel?.
Two crossovers set at the same freq.is redundant and likely to cause more problems.
Do the front speakers have their own X-over? whats the X-over point? and what is their freq. response (total) are they separates
Rear speakers same question.
I'll point out that you cant hear below 20Hz unless your a whale and very few instruments go that low except organs and synthasizers.
The subsonic filter merely block the lower harmonics from eating up amp power.
Their is no universal setting. all systems are different, as are cars, interiors, ears, windows up or down, noise floor, etc.
A RTA helps with the basics but you will still have to tune by ear,
Good sound is difficult enough to achieve,
Great sound is trial and error and very time consuming.
Sorry no simple answer here. Find a good installer ,preferably with sound judging experience,
It wont be cheap, but if you have enough money invested in the system, Don't skimp. or all you'll have is bragging rights
Best of luck, Sumthin

Posted on Jun 11, 2008

zapco
  • 30 Answers

SOURCE: how to adjust

hello . i think i can help ...u want to set your crossover points to 125Hz and for the subs if u want deep bass set them to 50 to 80Hz...try them and see what u like best

Posted on Jun 22, 2008

Professor_V
  • 92 Answers

SOURCE: I have a Kicker ZR360 CLASSIC AMP that puts out

THERE IS AN ISSUE WITH THE FEMALE CONNECTOR THAT IS SOLDERED TO THE PC BOARD THAT ACCEPTS THE CROSSOVER CARD. IF THE CROSSOVER IS PUSHED WITHOUT CARE, IT EVENTUALLY STARTS TO HAVE POOR CONTACT. THE CONNECTOR MUST BE REPLACED. YOU SHOULD BE ABLE TO FIND MY ADD FOR REPAIR UNDER ZIPCODE 70360. I AM NEW TO THIS FORUM AND DON'T YET KNOW HOW TO LINK TO MY ADD ON THIS SITE. YOU SHOULD BE ABLE TO FIND IT BY SEARCHING MY LOCAL ZIPCODE THOUGH. LET ME KNOW IF I CAN BE OF FURTHER ASSISTANCE......V

Posted on Jan 06, 2010

  • 1 Answer

SOURCE: yes i got a zr360 amp and i need a zrx crossover

I NEED A ZR360 CROSSOVER

Posted on Jul 16, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

They also try to play the bass


a crossover cuts the certain tones out of the sound.example: the high side cuts out low and mid tones,or the mid side cuts out high and low. The only problems this could be is that the crossover is not set right or not wired right. These speakers should be plugged into the high side of the crossover. If wired right and set right then your crossover is no good.

Mar 23, 2010 | Kicker KS13 Car Tweeter

1 Answer

My zr360 when i turn on the radio turns the subs to full pulsing bass very loud and there is no control. have to shut off the radio to stop it


yuor amp has an internal power supply problem,contact eric @ Capital Audio & electronics Repair 850-339-1130 we repair all namebrands & all models

Mar 16, 2010 | Kicker ZR360 Car Audio Amplifier

1 Answer

I have a Kicker ZR360 CLASSIC AMP that puts out very little sound until I push on the crossover module. Is something wrong with the crossover module or a connection on the amp itself?


THERE IS AN ISSUE WITH THE FEMALE CONNECTOR THAT IS SOLDERED TO THE PC BOARD THAT ACCEPTS THE CROSSOVER CARD. IF THE CROSSOVER IS PUSHED WITHOUT CARE, IT EVENTUALLY STARTS TO HAVE POOR CONTACT. THE CONNECTOR MUST BE REPLACED. YOU SHOULD BE ABLE TO FIND MY ADD FOR REPAIR UNDER ZIPCODE 70360. I AM NEW TO THIS FORUM AND DON'T YET KNOW HOW TO LINK TO MY ADD ON THIS SITE. YOU SHOULD BE ABLE TO FIND IT BY SEARCHING MY LOCAL ZIPCODE THOUGH. LET ME KNOW IF I CAN BE OF FURTHER ASSISTANCE......V

Dec 10, 2009 | Kicker ZR360 Car Audio Amplifier

1 Answer

Kicker zr360 in protection


unplug rca,disconnect spker turn on amp if light goes away start connecting with one rca and one spk wire and you will find the problem should go away '''''''make spk polarity is wright

Apr 07, 2009 | Kicker ZR360 Car Audio Amplifier

1 Answer

Help me with my system


More information is required to start solving your problem. (ie. your make and model of "1500W amp", the voicecoil configuration of the kicker and Audiobahn 15's, and why you want to encorprate 2 crossovers in your system)
Seems as If you have a system without a plan.
Head unit?
More info necessary to give you the best use of your components.

Jan 14, 2009 | KEF Audio PSW 2150 Speaker

1 Answer

How to adjust


hello . i think i can help ...u want to set your crossover points to 125Hz and for the subs if u want deep bass set them to 50 to 80Hz...try them and see what u like best

Jun 20, 2008 | Sony XM-2200GTX Car Audio Amplifier

1 Answer

Setting low pass and bass eq


the only thing that might damage equiptment other than playing it too loud would be running at 1 ohm if not supported by the amplifier.

as far as the eq and crossover settings, that is dependent on personal preference, and the acoustics of the paticular vheicle installed

May 15, 2008 | Hifonics Brutus BXi 1206D Car Audio...

1 Answer

Kicker zr360 amp


Double check that your ground wire is connected to the ground terminal, make sure the ground wire is not broken.

Oct 11, 2006 | Kicker ZR360 Car Audio Amplifier

Not finding what you are looking for?
Car Audio & Video Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

4861 Answers

yadayada
yadayada

Level 3 Expert

76132 Answers

The Knight
The Knight

Level 3 Expert

74243 Answers

Are you a Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...