How do I stop my washer from shaking alot - Samsung WF203ANW Front Load Washer

Are you overloading it? Or load uneven can cause this to happen.

bearing are shot if it makes a loud noise, or you put to much clothing in the washer.

shaking is generally due to inadequate floor structure under machine; i.e. plywood floor. in addition, if the washer is on a "pedistal" it will make matters worse; as the center of gravity is away from the floor. in rare cases, one of the drum "struts" can fall apart; and, cause excessive shaking. if you broke the locknut on one of the legs, unscrew the leg, and bring it to the hardware store for a replacement nut.

try moving the cloths around to even the load out my washer does this alot.

I need to know how long it ran before it died, and how hard it was shaking. Just the engine, shaking the car, or just in the sound.
Hightower971

Hi you must make sure its level in all directions. ie front to back and side to side. Alos dont overload it. If its on a wooden floor it will vibrate. A concrete floor is the best

Check to see if all shipping blocks and bolts were removed. Refer to installation and setup instructions for your model.

I once moved into an apartment furnished with washer and dryer. The washer had worn holes in the vinyl flooring and a neighbor said the previous tenant made her son sit on the washer to hold it down. I investigated and found the shipping bolts were still in place. The tub, which is supposed to be able to swing, was rigidly held in place, so the entire machine danced around the room!

make sure the transport tie downs have been removed during installation and that all four feet are adjusted properly so machine does not rock.Also make sure your floor is reasonably solid.

GHW9200LW same problem, going to call tommorow and ask.

Which machine exactly do you have ?