Question about Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum

2 Answers

How do I dismantle my Dyson DC58 to clean all filter etc

Posted by on

2 Answers

  • Official Brand Answer
  • 2,572 Answers

Hi David, it's Jack at Dyson.

We'd advise against dismantling DC58 any further than is shown in the User guide. This could cause damage to your machine not covered under guarantee - meaning any replacement parts needed could be chargeable. However, you can wash the lifetime pre-filter following the steps shown in the video below:

We recommend washing the filter at least once a month, using cold water without detergent. Make sure the filter is totally dry before replacing it, which could take at least 24 hours.

To clean any fluff or debris from the mesh shroud, press the red bin base release catch once to open the bin base. Then with the base still open, press the same red catch firmly a second time:

How do I dismantle my Dyson DC58 to clean all filt - dismantle-dyson-dc58-clean-all-filter-m43difmpidfjgfho0k5c5fgh-2-0.jpg

You can use a dry cloth or a soft brush to remove any debris from the mesh shroud.

It's normal for harmless static to cause fine dust particles to cling to parts of the bin, cyclone pack and behind the mesh shroud. This dust will not affect performance as the airflow doesn't need to pass through this. You should find tapping the cyclone pack gently when emptying the machine will help dislodge any clinging particles.

I hope this helps, but for further advice you can call our experts directly on 0800 298 0298 (UK), 1-866-693-9766 (US), 1-877-397-6622 (CA) or 1800 239 766 (AU).

Posted on Dec 08, 2014

  • Lynn Brandt May 25, 2015

    THANK YOU for this information, Jack! I always have a bit trouble understanding Dyson's "no words" user guides. Removing the clear cylinder to clean the mesh shroud inside has always been a hassle and this was just the information I needed! Thanks again.

×

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

THANK YOU for this information, Jack! I always have a bit trouble understanding Dyson's "no words" user guides. Removing the clear cylinder to clean the mesh shroud inside has always been a hassle and this was just the information I needed! Thanks again.

Posted on May 25, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

Tip

Dyson DC58 or DC61 - vacuum makes a pulsing sound (removing a blockage)


Dyson DC58 and DC61 handheld vacuum cleaners are engineered to make a pulsing sound to let you know if they're blocked. This could happen if an item too large for the machine is accidentally vacuumed up. Our video support guide will help you identify and remove any obstructions.

on Jun 04, 2014 | Dyson DC58 Bagless Cordless Hand Vac

Tip

Dyson DC58 / DC61 Animal handheld vacuum cleaner - Getting started



How to assemble and use your new Dyson DC58 or DC61 handheld vacuum cleaner.

on Oct 02, 2013 | Dyson Vacuums

1 Answer

My Dyson DC58 goes on and off in max mode


Hello, this is Ava with Think Crucial.

There are a number of reasons why your Dyson cleaner is pulsating off and on. First, it maybe due to a battery of the cleaner. Make sure that the power cable is properly plug to the power and seated properly from the unit while charging. If you find that the battery isn't charging at all, you may need to replace the battery. Second is to check the MAX button of your cleaner. If the button lights up and flashes when your Dyson keeps on pulsating, press and hold the power button and depress the MAX button to turn off the function. You may need to do it for a few times to get the hang of it. Third is to check for any blockages or clogs in the attachments. Look down through the tube and check to see if there are clogs on the sweeper end or if the roller is tangled up in fibers. Clean the roller brush are if it it's necessary. You may need to empty the dust bin of your unit as debris can build up in hard to reach places. Lastly, cleaning the filters may fix the pulsating of your cleaner. Remove the filter and rinse it with cold water and air dry it for 12 hours. Don't use detergent when washing your filters. If the pulsating doesn't go with the given quick fix, I suggest to contact Dyson for further assistance on this.

You can purchase a wide variety of high quality Dyson replacement parts for your Dyson vacuum direct from Think Crucial with free shipping and an exclusive 10% coupon for Fixya.com readers, use code: FIXYA10

https://www.thinkcrucial.com/search?type=product&q=dyson+dc58

I hope this was helpful.

Ava B.
Think Crucial Customer Care
http://www.thinkcrucial.com/

Dec 04, 2016 | Dyson DC58 Bagless Cordless Hand Vac

1 Answer

Dc59 bad smell Have cleaned the filter/canister correctly. however the smell appears to be coming from the dust which collects under the purple mesh how do I clean that out? Thanks


contact dyson support check www.dyson.com
whatever country you are from put country after the .com
eg australia is www,dyson.com.au
https://www.dyson.com.au/support/dc58-dc59/dc59-animal/maintaining-your-dyson-machine/wash-the-filter-video/not-resolved/obtain-telephone-support

Dyson has excellent customer support and having used there customer support I recommend giving them a call.

Jul 07, 2016 | Vacuums

2 Answers

Spitting Out Debris


the hose from brush go to the bag need to check for blockage you have to open there hose to clean

Aug 13, 2008 | Dyson DC07 Bagless Upright Cyclonic Vacuum

Not finding what you are looking for?
Dyson DC16 Root 6 Bagless Handheld Cyclonic Vacuum Logo

405 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dyson Vacuums Experts

AskDyson
AskDyson

Level 3 Expert

2572 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18391 Answers

Nick Olsen

Level 2 Expert

183 Answers

Are you a Dyson Vacuum Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...