Question about Akai LCT2060 Television

1 Answer

Problem with 20 inch lcd not stayng on

When you put on th e power goes to channel them powers off

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert who has answered 200 questions.


    An expert whose answer got voted for 20 times.

  • Expert
  • 367 Answers
Re: Problem with 20 inch lcd not stayng on

I just got done fixing an Akai LCT2660 that had four bad capacitors on the power board.Works perfect now.Hope this helps.Thank You very much!


Posted on Feb 02, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Phillips 40PFL3505D 42 inch tv stuck in channel search mode , continuous cycle

You can try to go back to factory settings.
After that disconnect the power from the TV and wait for about an or two hours. Then put on the power and try to make the installation complete from the start.

Regards GJ

May 25, 2014 | Philips 42PFL5332D 42 in. LCD Television

1 Answer

Troubleshooting 32 inch Philips LCD TV

Sounds like a power supply problem that typically is caused by a power surge of some sort. Check with tvrepairkit. com for their power supply kit to do the repair yourself.

Jun 19, 2012 | Panasonic TH-42PWD6UY 42 in. HD-Ready...

1 Answer

I purchased an Sony Bravia LCD 26 inch of KLV S200A series 3 years back. The LCD has now started developing problems like automatically the power goes off when any particular channel is being viewed and...

You have intermitant problems which may be caused by contact resistance or circuit overheating.After it cooled down the tv starts again. Leave TV on standby at all times.

Jan 03, 2011 | Sony BRAVIA KLV26S200 26 in. LCD TV

1 Answer


AKAI MODEL NUMBER PT50DL24 it turns on then goes off n all th screen says LAMP TEMP WHAT DOES THAT MEAN N WHAT DO I ND TO GET IT WORKING

May 10, 2010 | Akai CFTD2011 20 in. EDTV-Ready LCD...

1 Answer

My 20 lg powers up, red light turns green, but no picture comes up, the channel id shows then it goes dark. I can wait up to ten minutes still no picture unless I change the channel a few times then it...

You wont want to hear this.....

Green dots on a LCD screen are burnt out pixels and unfortunately are incurable other than having the TV serviced at a high price. One of the reasons it is a good idea to get a warranty on these types of TVs is primarily due to this very problem....burnt out pixels.

Please rate my help++++Thanks for using FIXYA

Dec 01, 2009 | LG 20LS7DC 20 in. LCD TV

1 Answer

Legend LCD tv power issue

the problem is inside th vga hdmi board ,i have repaired 2 of these units the 37 inch version and found a bad 100 mf 10 v capacitor . little bit of soldering/de soldering skill is needed . cost of cap 0 dollars got it from old radio. ernie

Feb 17, 2009 | Flat Panel Televisions

1 Answer

Akai lcd 2oinch tv

Your power supply is bad. This model came with a bad design. Your supply may have a green light on the black box, but it is putting out low voltage or amps. Replace it and you should be good to go.

Sep 27, 2008 | Akai LCT2070 20 in. EDTV-Ready LCD...

Not finding what you are looking for?
Akai LCT2060 Television Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Akai Flat Panel Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

Dave Naylor
Dave Naylor

Level 3 Expert

834 Answers

The Knight
The Knight

Level 3 Expert

66564 Answers

Are you an Akai Flat Panel Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides