Had a power surge and now my jvc sl47b-c tv will power on but only the jvc lofo will come up but no picture. buttons do not work on tv nor from remote. only way to turn off tv is to umplug it. would i

If you wish to buy its original remote control, contact the authorized service centre, or authorized dealer to your device brand. They can either give you a genuine remote control to your device, or can direct you, from where can you purchase a suitable one

Ur LCD inverter backlight board is dead.Replaced this LCD inverter backlight board,will get picture back.Tries these websites Shopjimmy.com,Ebay.com to buy a refurbish LCD inverter backlight board for the replacement.It a long board in shape.

Your lamp has blown. Time to get a new one.

the hyperlink button doesn't seem to be working, but just copy and paste this link into your browser. It is linked directly to your tv's replacement bulb.

http://www.discount-merchant.com/JVC-LCD-Projection-TV-Lamp-TS-CL110UAA-TS-CL110U-p/jvc-ts-cl110uaa-hd-56fn97.htm

If your TV was plugged into a power strip with a surge arrestor, the power strip may need a reset (if there is a reset button) or replacement (those surge arrestors are only good for so many "hits". Try plugging the TV in elsewhere.
If it was not plugged into a surge suppressor, it is time to call a repairman.

There is a way to reset television. I have a jvc 42inch that was just going to main logo screen and not beyond it. If i remember correctly you unplug the tv hold power button for 5 sec on tv then let go plug in and start. If that dont work unplug and then plug and hold power button on tv for 5 sec. It is 1 of those combinations. My tv worked after that. I googled my problem and a website listed that some tvs need to be reset.

Hello celiap,

There is no reset button in the way you are thinking of a reset button. However because the TV is responding with a blue screen this means that the tuner input might have been damaged by the power surge. Have you tried to see if the tuner can pickup analog channels? turn the TV to a station that is normally strong in your area and see it the station can be picked up. If it can the tuner is working and the problem might be in the connection, if this test fails then I would assume that the tuner is bad and needs to be replaced.

I hope this helps

Thank you,

Shuttle83

http://www.electron-age-technologies-llc.com

 Try this: Works with most crazed computer based devices.Remove power (unplug) unit for 1 minute then plug in

if you know how to solder ,resolder the amplifier your tv .or check speaker

Check for swollen top on power supply capacitor ......check
all caps with ESR meter....all with C900 series location #'s..
also check C523 in horiz drive circuit..............T.

Your power transformer is likely shot. It'll cost at least $200 to have it replaced. Someone can come to your house to diagnose it. Usually costs around $65.