Question about Sony FD Trinitron WEGA KV-36FS120 36" TV
Tried reset, just keep hitting the on button about 30 times!
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I have your service manual but I can't find any reference to 9 flashes, are you sure it is 9 with out a pause?
see below from manual.....
Posted on Jan 31, 2008
My Sony KV36HS500 Trinitron is doing the same thing. Last night the next street over was hit by lightning. The "7" blink pattern was happening, so like the manual stated, unplug it for 4 hours. Which I did. The t.v. is back up and running fine. It's a nice t.v., better than the plasma I paid over a grand for, that's already shot. It's a good t.v. and good that Sony put in the stand by protection to prevent the t.v. from dying an unnecessary young death. Patience, don't rush it, unplug the t.v. and leave it sit. Also, don't use a power strip, that was my mistake, and unplug your t.v. if storms are in the area, I was too lazy to and now I had to deal with this, in 8 years, only twice did this happen. I'd buy another one tomorrow if they still made them.
Posted on Jun 15, 2008
The relay is in the power supply area. I am sure that the fault is not the relay.
It is very common that there are various components starting to go off spec from age. Most of the failures are in the scan amplifiers and power supply areas.
It is also possible that the CRT emission is too low from age. What happens is that it is on the minimum edge and this explains why the set may turn on some of the time.
When the main uPC in the set sees any potential fault conditions it will go in to a protection mode to prevent damage and to be safe. Your set is probably borderline to operate.
Considering the age of your set, I would be shopping for a new TV set.
Posted on Jul 12, 2008
Hello,For model KV-40XBR800,
Pls check following area.
Low HV Shutdown:
On the D Board.
Check IC8004/pin 7 should be 7.4v.
Check IC8006/pin 2 should be 2.5v if lower will trigger shutdown by causing pin 1 to turn on.
Check IC8006/pin 3 reference voltage 2.2v.
IC8006/pin 1 normally at 0v. If high
turns D5007 ON which turns the latch circuit Q6532,
Q6530, and Q6527 ON and turns the AC relay RY6501 OFF.
And NOTE: 6 blinks also can be Low B+ protection.
Unregulated 7.5 v from the power supply to 5v reg IC504 on the A Board. 5v to M Board Q2314
to CPU IC2300/pin 43. If 5v missing set will shutdown with 6 blinks.
Posted on Oct 15, 2008
Tips for a great answer:
Dec 02, 2014 | Sony FD Trinitron WEGA KV-36HS420 36" TV
Nov 17, 2010 | Sony FD Trinitron WEGA KV-24FS120 24" TV
Oct 16, 2010 | Sony Grand WEGA KDF-55WF655 36" Rear...
Aug 25, 2008 | Sony FD Trinitron WEGA KV-24FS120 24" TV
Jul 19, 2008 | Sony FD Trinitron WEGA KV-27FS100 27" TV
Jun 29, 2008 | Sony FD Trinitron WEGA KV-32HS500 32" TV
Jan 13, 2008 | Sony FD Trinitron WEGA KV-36FS120 36" TV
Dec 28, 2007 | Sony FD Trinitron WEGA KV-24FS120 24" TV
38 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: