Question about Fujitsu Siemens SCALEO 600 (FSP:83C005617) PC Desktop

1 Answer

No power just went dead, tried to re start but no power

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert that hasĀ over 500 points.


    An expert who has answered 200 questions.

  • Expert
  • 306 Answers
Re: no power

Unplug the pc and push the power buttun in....reconnect the power cord and try again. if no luck try a differ plug in. if that fails then the power supply in the pc is fried and needs replaced

Posted on Nov 11, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Common faults

If power supplier is working, check the start button. Make sure that all the wires are conected in the motherboard and there is no loose wires.

Oct 26, 2013 | PC Desktops

1 Answer

When turning on my emachine desktop the monitor states no signal someone suggested that I need a fuse, Where would that fuse be located?

hello if the monitor wanted a fuse .. then it wont turn on.. which means its getting power !!!
you problem is the pc ,or monitor cable fell out at the back of pc, or you may have a defective memory stick ,that if the pc is getting power and you are seeing light on the pc.. if the pc is dead nothing lighting.. no beeps, not even the optical not opening then you have a power supply problem,
if u had a surge be it went dead try this, unplug system for 5 mins, the plug it back in, try powering on.. if still nothing , most likely , memory,video card or power supply is defective, but i think. its your memory if getting power

Jan 22, 2011 | E-Machines T6528 PC Desktop

1 Answer

Hello, my HP Pavilion desktop PC m9177c went dead after a power outage. Right before the outage, it was on and connected to a surge protector. After the outage, it is completely dead as if there is no...

You may have to change its power supply however, try this first

1. change your UPS coz the old one may have been damaged.

if that still didn't work, change your power supply

Nov 28, 2010 | HP Pavilion a710n (PJ508AA) PC Desktop

1 Answer

My Sony Vaio VCG-RB53 will not turn on. Just went dead. Other peripherals on the same power source are fine. I first got a black screnn with white writing and it tryed several times to start Windows XP and...

It could be the PSU (power supply unit), one that has a fan working and where the power cord goes into. If that goes bad then the computer becomes dead as there is no power going to any of its systems. If there is any sign of life in the computer then you can try by removing the RAM and reinserting them. Or by unplugging the connector from the PSU to the mother board. But remember to plug it in in the same way that you remove it from. remember it by the color of the cables. If by mistake you turn the connector by 180 degrees then the mother board will get burnt.

Nov 02, 2009 | Sony VAIO VGC-RB53 PC Desktop

2 Answers

My Gateway 503 gr quit turning on. At first it chattered a little and then went dead. Now it won't even do that. The power supply has been replaced with a new one but no change. I need to see if the power...

Check the condensators. If there are not any blown condensators or leakage, keep the video card (or at least the one on board if any) and remove all the other cards, also the memory. Check the CPU with a known good motherboard. If the CPU is ok begin by adding the memory, one bar at a time (you may alternate the slot also). If the computer do not start the motherboard is defective . If the computer starts but no sound is heard motherboard could be defective. Try to install a previously checked memory. If you do not get any signal the board is dead. If you get video signal, add one card at a time until you identify the bad component.

Oct 04, 2009 | Gateway 503GR PC Desktop

1 Answer

Sony notebook vgnn325e/w I was using the notebooke when it just shutdown and cannot be power up again. The computer is dead.

Your Mainboard moslty likley went bad and will need replacing. Check all the usuals. Is ther power lights when plugged in? Charge light o Battery?
Remove both of those and wait a while and put back in and try booting.

Remove any removable media like the CD drive. Also try powering on with the power adapter plugged in and the battery removed.

Jan 04, 2009 | PC Desktops

1 Answer

TFT monitor went dead

How old is your TFT Monitor?
It looks like the Monitor has got some problem.
First, make sure the cables are connected correctly.
Try Changing the connecting cable (between monitor and pc) with another one.
Try using another monitor with your pc & using same cables.
If the problem persits, pls try your monitor on another Computer.
This is all what you can do, if the problem wasn't solved, then maybe the problem is in the monitor that you need to take it to a specialit to repair it for you.
I hope my steps were helpful.

Nov 06, 2008 | PC Desktops

3 Answers

HP Compaq D530 sff Will not power up

sounds like your power supply went out.

Nov 16, 2007 | HP Compaq d530 PC Desktop

Not finding what you are looking for?
Fujitsu Siemens SCALEO 600 (FSP:83C005617) PC Desktop Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Fujitsu PC Desktops Experts


Level 3 Expert

5660 Answers

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Carlos L. Burgos
Carlos L. Burgos

Level 2 Expert

508 Answers

Are you a Fujitsu PC Desktop Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides