How to program sleep timer on R130C1 RCA remote

Universal remotes have have very few options, just basics such as volume, channel, mute, power. Sleep timer will not be there. for that you need to get the original remote.

You can get a replacement at remotes.com. The original for your set is discontinued, but there is a substitute available.

remotes.com link:

RCA R130C1 Remote Control

you probably need to go for a universal remote , and check as the problem might be on the existing remote may not be working and then using the universal remote , u can undo the changes you have done .

HI,
CHECK THE FOLLOWING LINK . ON SEARCH TAB TYPE RCA . YOU WILL GET ALL THE LISTED RCA REMOTE CODES AND HOW TO PROGRAM IT.

Electronics Equipment Repair Center

Programming the Sleep Timer:

1. Press and release the TV key.
2. Press and hold the SLEEP key for three seconds. The illuminated component name turns on.
3. Release the SLEEP key.
4. Using the number keys, enter the desired time in minutes (from 1-99 minutes). To set the timer to an umber under 10 minutes, first press 0 and then the desired number (e.g.,05 for five minutes). The illuminated component name blinks with each key press.
5. Once the second number is entered,the illuminated component name turns off.
   Tip Any key press other than the number keys is ignored. If you don't enter the sleep time within 10 seconds after pressing the SLEEP key, you must start over at step 1. The illuminated component name blinks four times and then turns off, indicating your attempt to program the Sleep Timer has been unsuccessful.
6. The Sleep Timer is now set.
7. Leave remote aimed at the TV. Once the Sleep Timer is set, you can continue to use the remote without affecting the Sleep Timer. However, because the timing mechanism for the Sleep Timer is built into the remote itself, the remote must be in TV Mode and pointed at the TV to activate the Sleep Timer.
   Note: If the ON·OFF key is pressed, the Sleep Timer is canceled.

just get a uneversal remote it will be so much easyer.

Hi there,

Well you may please follow the steps below -

Step 1: Press and hold the "SLEEP" key, then release. The indicator light will stay lit.
Step 2: Enter time in minutes using the numerical keypad (from 1 minute to 99 minutes). For 1 to 9 minutes press 0 before the actual number. The indicator light will go off. Leave the remote aimed at the TV set.
The Sleep timer program can be cancelled (reset to zero) by pressing and holding the "SLEEP" button until the INDICATOR LIGHT blinks or by pressing the ON/OFF button.

Good Luck!!

Thanks for using FixYa!!

when on sleeper on,while switch off and again if on,the sleeper on Timer cancel.

In most cases you can set the sleep timer by accessing the menu. Or if it is a learning remote find a button you dont use and teach it the sleep button from your OEM remote.

try repairhelper.com