Question about Heating & Cooling

1 Answer

My heater won't start unless I hit it on top

I hit the top of the get it to start

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 83 Answers

Check the thermostat. Make sure to unplug and clean unit before inspection.
Dust can cause a problem and create a similar problem.

Posted on Nov 30, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

96 Monte carlo z34 won't crank over unless I jump


Sounds like a problem with the key switch, probably the security system. You may only have power to the fuel pump when the engine is cranking.
Is the security light on or flashing ?

Jun 29, 2013 | Cars & Trucks

1 Answer

2003 ford focus...won't start unless it's manually choked under the hood


How do you choke a dry intake system

All your doing is reducing air intake during
the starting

That should tell a trained technician something

Have to look at all data with scan tool & go for a road
test & collect data

We can't guess over the internet you need the car

It is all about testing every vehicle component until
something is not as it should be & then correcting that

Mar 07, 2013 | Cars & Trucks

1 Answer

My top dishwasher drawer won't finish through the cycle. It runs fine on rinse only but not any of the wash cycles. It stops mid cycles, beeps like it has been paused, then tries to start again


Try to feel the temperature of water inside the dishwasher. If it is normal room temperature for the hot wash cycles then it is likely the heater is faulty.
It is not easy to replace unless you have good experience with repairing dishwashers.

Jan 17, 2013 | Fisher and Paykel 23 in. DD-603 Built-in...

1 Answer

Transmission problems for 98 dakota


Pull it out & have it rebuilt

Can pull the valve body & clean, if you like
doing that kind of work,doubt it will be the total
solution

Nov 25, 2012 | Cars & Trucks

1 Answer

Loud knocking


Sort of sounds like the timing belt broke-- if you have one

The valves may have hit the pistons & that is why it won't turn over

I don't know any of that is true & won't wish it on anyone,but
it is a place to start

Sep 13, 2012 | 2001 Saab 9-3

1 Answer

Put in new starter in 2003 ford expodition and it still won't start what can my problem be won't even turn over?


Smart lock? do you have a picture of a red hand on instrument panel? With falcons quite common. Turn & hold key @ start posision, Hit dash upwards on left side of steering colum, If start = faulty smart lock module. I don't know if expodition has smart lock but probably does

Jun 15, 2012 | 2003 Ford Expedition

1 Answer

Ac/heater blower motor fluxuates in speeds blows vary slow then quits!


has a short and needs to be cleaned you can buy canned air at wal-mart to try first

Jun 15, 2012 | 1996 GMC Jimmy

1 Answer

Laptop back to factory settings


What brand of laptop?
You'll need a set or restore discs unless there is a restore partition on your hard drive. Getting into Recovery to set the system back like it was when you purchased it will require you hitting a F1 thru F12 key when you hit the power button? Sometimes there might be a recover listed in the programs list when you click Start/Programs.

Have you tried a System Restore? It's better because you won't lose your data, documents, music, pictures, videos and programs (unless the program was installed after the restore date you select).

Mar 31, 2012 | Computers & Internet

1 Answer

When my car sits for a few days without driving the car will not start, is there like a kill switch or something that causes this?


No kill switch

The Fuel Inertia Switch --- is only on Ford Products
& will not be a problem unless you were in a very heavy hit
Then your car would most likely be totaled

I would think your battery is no good, IF, it is from the factory
& never replaced
Have you not tested it, on the days it won't start?

What does it take to get it started?

Have you checked fuel pressure or had
someone under car listening for the fuel pump ?

Aug 12, 2011 | 2007 Ford Five Hundred Limited Sedan

Not finding what you are looking for?
Heating & Cooling Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Heating & Cooling Experts

paulcarew

Level 3 Expert

2514 Answers

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Donni Steen

Level 3 Expert

659 Answers

Are you a Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...