Question about Garden

1 Answer

I have a Ryobi 430 4 stroke weed wacker try to start this morning seems like it was frozen up took spark plug out pull the string free flow rotates easy put spark plug back in very hard to start fraid I'm going to break the string help

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

Paul you might want to replace the spark plug, make sure the gap on the plug is correct, make sure there is oil in the machine, some have a safety switch when the oil is low. If you cant buy a new spark plug you can sand off the tip that is probably black and replace it in the machine

Posted on Nov 28, 2014

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: Ryobi string trimmer 32.1 what do mix gas and oil or just gas?

Ryobi trimmers I have had use a 32:1 oil mix. Just pick up a little bottle of Ryobi 2-cycle oil and read it to see that it will give a 32:1 mix in a gallon of gas. Pour it into a gallon of gas, and maybe a little fuel stabilizer too, shake it up and you should be good for the season.

Posted on May 28, 2008

boscia
  • 163 Answers

SOURCE: weed wacker

check the fuek lines for hole and leaks, check the fuel filter and clean if necessary. remove the carbuerator and inspect the gasket; it should be soft and flexible, if it seems hard or brittle replace it. clean the carb with carb cleaner sray (available at any local auto parts store) and compressed air. make sure you get inside the small fuel rail holes. if that doesn't work have the carb repaired at a service center or replaced.

Posted on Nov 28, 2008

#1 Taper
  • 1040 Answers

SOURCE: How to change the string

If it is a duel line trimmer then:

Cut two separate pieces of string, about 7 ft. each.

Stick the end of the line in the hole on the inside of spool.

Wind clockwise onto spool, putting the line that is closest to the ground on first.

Once you have winded this piece on, lock the last 4 inches of line through the slits on spool.

Repeat process for second piece of line, locking the last 4 inches in slot opposite the other locked in piece.

Put the spool on the trimmer, feeding the end of lines through either hole on trimmer.

Before you push the spool all the way on, pull the strings out of the locked position.

If it is a single line trimmer, just wind a single piece of string clockwise onto spool.

Jim

Posted on Jul 03, 2009

  • 3 Answers

SOURCE: How do I restring my Ryobi weed wacker

Start in the center ,snap the center in place. than put the ends out through the holes.

Posted on Jul 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Ryobi 430 4 stroke weed wacker frozen up can not pull the string take spark plug out very easy to pull full rotation easy to pull when you pull the string put the spark plug back in you can pull...


When you remove the spark plug is it very wet?
after the plug is removed when you pull the cord sharply does liquid come out from the hole?

Nov 28, 2014 | Garden

1 Answer

Help my weed wacker string


Pull the spark plug out and try pulling it over if still won't move might have seized the motor possible not enough oil in gas You can try if not to much damage done pour some kerosene or stove oil down spark plug hole let sit over night try again

Jun 08, 2013 | Garden

1 Answer

Should I use regular unleaded gas with oil or ethanol free gas with oil for my ryobi weed wacker?


If you can get ethanol free fuel this is what you should use with a good quaility two stroke oil designed for chainsaws ( not out board boat engines )

Jan 24, 2013 | Garden

1 Answer

The Ryobi28020 weed eater seems to be flooded


Do not choke,Hold trigger down and pull the starter several time to clear the carb. of gas . You may have to remove the spark plug and dry it.

Aug 16, 2012 | Ryobi 30cc 17" String Trimmer Zrry30530...

1 Answer

I have a RYOBI E530 Touch Start Push Button weed wacker. Model RY29550. I took it in for repair since the cord wouldn't recoil back in and was told to just use the batter/electric start. I do not...


Most Ryobi manuals are available on their site: http://www.ryobitools.com/discontinued_manuals/ . The direct link to the RY29550 manual is: http://www.ryobitools.com/product_promotion/discontinued_manuals/string_trimmers/RY29550_310_trilingual.pdf .

Are you sure of the model number? The RY29550 lists electric start with 12V battery for all models, no pull cord. It takes battery pack 130269012 and charger 140295003. This site has parts for the RY29550: http://www.ereplacementparts.com/ryobi-ry29550-string-trimmer-parts-c-7931_15633_15647.html .

I hope this helps.

Cindy Wells

Jul 10, 2011 | Garden

1 Answer

Have a Ryobi weed wacker 725r 31cc click link Trimmer Plus. No more line-can't figure out how to remove bottom to replace the line or what kind of line to replace with. Deceased husband lost directions...


i also have a ryobi weed wacker. if it is the same. you don"t have to remove the button. line up the 2 arrows one on wheel with bumpy edges and one by the button. you should see 2 holes feed a 2-3 foot piece of line into the hole the line comes out of for cutting and it should come out of a curved holw on the bottom by the button .tuck the end into a small round hole . pull line tight (tug on the section that you cut with). wind the string by turn the ring around the button. til desired length. if this doesn't work. google you model # and look for a manual (manual for ryobi weed wacker model # ------------.)

Jun 09, 2010 | Garden

1 Answer

The string head does not spin as fast as the


it sounds like the centrifugal clutch is slipping. take it to several shops and get some quotes. Most times you'll find that fixing a Ryobi is more expensive than buying a bnew one.

Sep 02, 2009 | Ryobi 30 Cubic Centimeter Curved Shaft Gas...

1 Answer

How do I restring my Ryobi weed wacker I do not know which end of the string to start with?


Start in the center ,snap the center in place. than put the ends out through the holes.

Jul 10, 2009 | Ryobi Garden

Not finding what you are looking for?
Garden Logo

Related Topics:

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top Garden Experts

Dennis Key
Dennis Key

Level 3 Expert

2478 Answers

roeb

Level 3 Expert

570 Answers

john h

Level 3 Expert

12650 Answers

Are you a Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...