Question about Pioneer Televison & Video
Remote is an axd7368. Stopped working previously (last couple of weeks) that turned out to be the Main/Sub/PDP switch bottom left had been moved by the kids, switched back to main and was ok, fine for a week, now stopped working again, unit stuck in DVD mode, therefore cannot switch to tv via the top buttons on remote?
Check the remote control for its infra-red emission. Check it with fresh batteries. Check by pressing all the buttons on it; and see whether all of it generates infrared signal while pressing. If it is found OK, check and replace the infrared sensor inside the TV. If you wish to get some details; check the site linked here. It has details about how to check a remote control; by one among the post. Surf the site with patience. Pull up older posts. http://electronicshelponline.blogspot.com/ If the remote control is found OK; check and replace the infra-red sensor inside the TV. Contact any service technician
Posted on Nov 22, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
On the sky box do the following.
Check scart to tv is in the correct socket marked TV.
Try pressing services
then system setup
then picture settings.
Then try switching scart control to on or off.
If this sorts it great. If it doesnt check scart lead has all pins wired & not only A few.
Posted on Jan 20, 2008
These units have had a failure in either logic board or the main board. The only way to repair these units is to get replacement boards and see if this repairs the problem. You can try to source these parts at e-bay. Use the search engine, plug in the make of you television model number, and part number of the board you think you need for the repair.The search engine will bring up all available parts for you.You can also try this website for parts. http://www.discount-merchant.com/SearchResults.asp?Cat=&Search=PCB&RefineBy_Manufacturer=MINTEK I hope this information is of some help to you with your problem.
Posted on May 29, 2009
As you all know this is a very common problem. It is located in the two power boards inside the machine. These media receivers run really hot and the solder on these circuits boards crack, thus losing power when hot. Leave to cool and ok again. To fix you can remove these boards and touch each solder joint with a fine tip soldering iron until it becomes molten then move on to the next joint. Do all the joints, reassemble and presto, you should be back in business. These board are located between the on-off swith and the rear power input. It is a little fiddely, but if you halfway competant, then it shouldn't be a problem. I've done it a couple of times now, so if anybody feels a bit nervous, I'll do it for them for a small fee. contact firstname.lastname@example.org
Posted on Jan 14, 2010
Tips for a great answer:
Dec 21, 2015 | Televison & Video
Apr 10, 2010 | Pioneer DVR-5100H DVD Recorder
Mar 24, 2009 | JVC XV-N652
Nov 21, 2008 | Pioneer Televison & Video
Apr 03, 2008 | Televison & Video
Mar 26, 2008 | Televison & Video
Sep 08, 2007 | Pioneer XVDV830/SDV830 DVD AUDIO HTP...
75 people viewed this question
Usually answered in minutes!