Question about Cell Phones

1 Answer

I have a Huawei y301A1 smartphone the signal is not strong it keeps jumping from 3g to 2g how can I boost my signal strength

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

There is a small antenna that you can buy it tapes underneath your battery. It usually only gains you about one bar of strength . Most likely its the area you're in. try going to a different area and see if your strength increases if it does it is the area that you're in and there's not much else you can do about it . That is one of the cheaper phones out there.

Posted on Nov 20, 2014


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 2047 Answers

SOURCE: HI my W902 is hanging on 2G & not switching

If the phone is setup so that it should switch between 2G and 3G and yet the phone does not switch there are a couple of likely causes first of which is the availability of the 3G network on your service provider. Most service providers have the 3G network only in certain areas try to confirm from your survice provider that the location is 3G supported.
secondly your phone might not have capacity to access the 3G network which is being broadcasted and auto + good 3G signal is circumstantial and therefore will determine how you receive. Auto comes first so the phone does auto and while doing auto finds 2G and sticks to it before even searching for 3G.
If you have the option of 3G + good auto option this will enable you get 3G better.
Hope this solution has been helpful?

Posted on Dec 31, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have already 3g network on my area..but sometimes it is not load 3g net...only 2G net were to get full 3G?

Most likely, when it only loads 2G, you are in an area where there is not a strong enough signal. There is not much you can do about it, it depends on the coverage from your carrier.

Dec 18, 2016 | Cell Phones

1 Answer

Dropped in cup of water now wont turn on when i charge it a read light shows but nothing else

sad to say but if you have not tried to DRY it there is not help but to replace it .

Aug 22, 2015 | Huawei ASCEND G630 BLACK 4GB FACTORY...

1 Answer



Even if you did it wouldn't work as a Verizon Moto G serial number doesn't have permission to be on Boost/Sprint network.

Motorola Support

Jun 01, 2015 | Motorola Mobility GOOGLE 8GB MOTO G XT1032...

1 Answer


If the device has worked for you in other locations, the most likely answer is that you have low signal strength from your network carrier to your device. To test if low signal strength is the problem, try moving your laptop to another location, closer to the cell tower you think might be servicing you to see if it starts working. If your laptop connect software has the ability to show you the signal strength, look to see how many dBm the signal strength is. The larger the negative number, the worse it it. Below -85 dBM, you will have frequent drop outs.
-75 to -80 dBm should give you usable results. -65 dBM and lower should give you very good results. If you can only find the strength in bars, 1 or 2 bars is bad, 3 bars marginal, 4 & 5 bars useful to good. You can buy repeater devices which pick up cell signals and rebroadcast them, making them stronger for you laptop to pick up the cell signal. They usually have an external antenna port which you can put outside and high to help pull in the signal. Trees, hills, and rain all block and lower the signal strength between you and the cell tower. Distance is also a big factor.

Jan 06, 2015 | T-Mobile Huawei T-Mobile Webconnect USB...

1 Answer

I have a Huawei y301A1 smartphone my speaker sounds like it's blown how can I fix it

Using external headset or return the phone is not worth trying to repair

Nov 20, 2014 | Cell Phones

1 Answer

2g singnal on work GPRS signal only. EDGE signal not working?

Oct 04, 2013 | Pantech Sky Vega Lte Ex Im-a820l Lg U...

2 Answers


Please specify what problems you are having with your device so that I can help in a more informed manner.

Sep 18, 2013 | Universal HUAWEI T8100 2.8"" Touch Screen...

1 Answer

I have Tata Photon+ Huawei Modem EC1261, working perfectly. I want to use this device with other SIM (2G/3G). But this device has only MEID (14 hex-digits) and don't have IMEI. I have verified this already...

I have Tata Photon+ Huawei Modem EC1261, working perfectly. I want to use this device with other SIM (2G/3G). But this device has only MEID (14 hex-digits) and don't have IMEI. I have verified this already with Tata Support Personal. Can you unlock this Tata Photon+ Modem?

Jan 12, 2011 | Computers & Internet

1 Answer

Can you please tell me how to work out if my iphone is 2g or 3g

Its quite simple, Just see near the signal strength icon on the top left hand might see a 3g or 2g written der...

May 27, 2010 | Apple iPhone Smartphone

Not finding what you are looking for?
Cell Phones Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cell Phones Experts

Computer Repairing
Computer Repairing

Level 3 Expert

14641 Answers


Level 3 Expert

76164 Answers

William Alequin

Level 3 Expert

928 Answers

Are you a Cell Phone Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides