What is the oil capacity of a 1988 Hino 6.1Litre engine?

The oil capacity for a Hino Dutro with the SO5D engine can vary slightly depending on the exact model and year. However, as a general guideline, the engine oil capacity for the Hino Dutro SO5D engine is approximately 8 to 9 liters (about 2.1 to 2.4 gallons) of engine oil when equipped with an oil filter change.
Please note that it's always a good practice to consult your vehicle's owner's manual or service manual for the most accurate and specific information regarding oil capacity and maintenance intervals for your particular model and year. This will ensure that you use the correct oil type and quantity for your vehicle.

Code P1266 on a HINO 700 can indicate a fault or issue with the injection control pressure system. Here are some steps to fix this code:

1. Check the engine oil level and ensure it is at the correct level. Low oil level can cause issues with the injection control pressure system.
2. Inspect the oil filter and replace it if necessary. A clogged or dirty oil filter can restrict oil flow and cause pressure issues.
3. Check for any leaks or damage in the injection control pressure system. Look for oil leaks around the high-pressure oil pump, hoses, or fittings.
4. Inspect the fuel injectors for any signs of damage or leaks. Faulty injectors can cause issues with the injection control pressure system.
5. If there are no visible issues, it may be necessary to use a diagnostic tool or scanner to further troubleshoot the problem. The scanner can read and interpret the error code and provide more specific information on the exact cause of the issue.
6. If you are unable to identify or fix the issue yourself, it is recommended to take the vehicle to a qualified mechanic or HINO dealership for further diagnosis and repair.

Keep in mind that these steps are general guidelines and may vary depending on the specific model and year of the HINO 700. It is always best to consult the vehicle's owner's manual or seek professional help for accurate and specific instructions.

Dry fill: 7.5 L (7.9 US qt, 6.6 Imp. qt)
With oil filter change: 7.0 L (7.4 US qt, 6.2 Imp. qt)
Without oil filter change: 6.4 L (6.8 US qt, 5.6 Imp. qt)

Refill
oil amount with oil filter change: 4.25 quarts Refill oil amount without oil
filter change: 3.875, depending on engine size as well, this could be up 5ltrs..

Fuel tank, 17.2 gallons. Radiator capacity, 1.25 gallons. Oil capacity 4.5 quarts with the filter. Oil pressure, 20-50 psi.

1996 Isuzu Truck Trooper 3.2L MFI SOHC 6cyl
The Engine Oil Capacity 5 7/10 Quarts (including filter)

Engine Oil Type and Weight
Oil for use in temperatures ranging from -13 to 100 degrees
5
Application:
Oil for use in temperatures ranging from -13 to 100 degrees
Note :
Quarts without filter change

Oil for use in temperatures ranging from 32 to 100 degrees
5
Application:
Oil for use in temperatures ranging from 32 to 100 degrees
Note :
Quarts without filter change

VALHD30
Application:
Oil for use in temperatures ranging from 32 to 100 degrees
Note :
Valvoline Premium Conventional 30 Motor Oil


Hope this help (remember rated and comment this). Good luck.

on most vehicles the oil filter is can shaped and mounted on the engine block, and will be found from under neath of the vehicle to change the oil 1 jack the front of the vehicle and secure it on stands 2 place a collection pan under the vehicle (large enough to hold the vehicles oil capacity) 3 remove the plug on the bottom of the oil pan to allow oil to drain 4 use an oil filter wrench to loosen the oil filter (it will contain oil as well) 5 allow several minutes for oil to drain, the longer the better 6 replace the plug 7 pour some oil into the new filter, and oil the rubber gasket on the new filter 8 replace the filter by hand (do not use filter wrench to tighten) 9 tighten the new filter by hand to one full turn after the gasket touches the engine and no tighter 10 refill from the top of the engine to vehicles oil capacity with recommende weigth of oil note. the engines capacity and the engines capacity with filter differ for the filter will hold oil as well 11 lower the vehicle from jack stands change every 3000 miles when driving in town change every 5000 miles when driving on highway

go to a parts store and they will give you all the right supplies and tell you how to do it. There is a drain plug on the bottom of your oil pan take plug out and let oil drain. Take out oil filter by hand or with a oil filter wrench. Take new filter and fill it with as much oil as you can without spilling it all over putting filter back in, apply a thin coat of fresh oil to the rubber ring on the oil filter and screw it back on the engine hand tight (do not tighten using a wrench). Put drain plug back in. Fill engine back up with oil. Replace oil cap> Done.

1998 4Runner 3.4V6 Engine oil capacity is

5.5 Quarts with oil filter change
5.2 Quarts without filter change

If you have the 4.7 liter  V8 with the engine code (N) 5W-30 If you have the 2.5 liter, 3.9 liter, 5.9 liter 10W30 but 5W-30 can be used under cold climate condition. (Alaska)
Capacity with filter 4.7 engine 5.7 liters of oil Capacity with filter 2.5 engine 4.3 liters of oil Capacity with filter 3.9 engine 3.8 liters of oil Capacity with filter 5.9 engine 4.7 liters of oil
Good luck and hope this helps.