Question about Kenmore Elite 21086
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Sounds like your front to back spring is pulling to tight, sometimes you need to replace it and sometimes you can take it off and stretch it. hope this helps
Posted on May 20, 2007
SOURCE: Very loud spin cycle
your bearings i the tub have gone bad. It happens usually if you use powder soap. It doesnt dissolve all the way and gets into the bearings and ruins them. Sorry but this is a pretty expensive fix. When you get it fixed used liquid soap and it shouldnt happen again.
Posted on Nov 18, 2008
to cause unit to go off balance taking in fact that you put clothes in washer even...check your counter balance spring it hold the tub to base at rear of unit,,,and check your balance ring at the top of your wash basket its fill with water if cracked will cause this problem,,
Posted on Dec 24, 2008
have you tried lower spin speeds? I found with heavy items such as towels and jeans it is best to lower the spin speed. also washing like heavy items on a certain wash cycle is best - i.e. towels on bluky/bedding.
hope that helps.
Posted on Apr 09, 2009
If this is occurring mostly on heavier loads your clutch may be slipping. If you take a flathead screwdriver and push down the lid switch so the washer will spin with the lid up, grab the inside of the drum. If you can easily stop the drum its most likely a bad clutch. If you tip the washer back and see oil underneath then its probably your transmission leaking oil onto the the clutch causing it to slip (in which case you need transmission and clutch assy). If you see oil I would probably not bother calling a tech it would be a pretty expensive repair.
IF the problem is with the clutch only it may be worth repairing but to replace the clutch you will have to remove the pump, motor, transmission, and the clutch mounts on top. The other less common possibility could be a bad drive block under the inner tub. hope this helps. _MJ_
Posted on Jan 28, 2010
Tips for a great answer:
Dec 26, 2015 | Washing Machines
Feb 28, 2015 | Kenmore 24032\24036 Top Load Washer
Aug 09, 2013 | Kenmore Elite Oasis 27052 Top Load Washer
Nov 15, 2009 | Kenmore Elite 45986 Front Load Washer
Oct 15, 2009 | Kenmore 23822 Top Load Washer
Jul 23, 2009 | Washing Machines
Apr 08, 2009 | Kenmore Elite 45986 Front Load Washer
Apr 02, 2009 | Kenmore 3.2 cu. ft. Plus Top Load Washer
Aug 03, 2008 | Kenmore Elite HE4 Electric Dryer
May 27, 2017 | Kenmore Elite 21086
44 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: