Question about Boating

1 Answer

How do fix a power trim switch not working on a 2002 mercury 50 elpto

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • Expert
  • 456 Answers

Replace with new one

Posted on Nov 17, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What year is my 75 hp mercury 4 cylinder serial number 0a986452

Locate the serial number plate by looking on your motor's transom bracket; the plate will have "Mercury Marine" written on the top. The serial number is the top number on the plate. The number directly beneath this is the year it was manufactured.
The year will be determined by the number of cylinders,,,
A 4 cyl. is a 1986 .
75 - 4 Cyl. 1986 ELPTO, ELO A197882 - B249479 = U.S. Serial Numbers A70708 = Canadian serial numbers

Jun 25, 2017 | Mercury Boating

1 Answer

Boat manual

it normal would be on top of the motor were all your electrical comes into the motor .you would see 50 amp fuses next to them there should be 4 round black contactors that have all your wires from your tilt motor and your trim motor connected to them. but if it still works its not the contactors .try this have some one pull up on the outdrive while you hit the switch . if it goes up its your tilt motor has water in it or was damaged by hitting something . water damage is fixable only if its fresh water .salt water you need not waist your time . buy a new one .and if it is fresh water ,if you no how to take stuff apart and putt it back togeather again...the tilt motor need to be cleaned ,up and new seal kit put in it .it should work fine again .

Jul 28, 2014 | Transmission & Drivetrain for Mercury...

1 Answer

2000 Mercury 115 ELPTO impeller replacement. The Quicksilver replacement kit comes with various washers / face seal. The water pump housing didn't have a seal on top of the old one. Am I supposed to use...

if you mean a large flat sided 'O' ring then this is to help keep water in the impellor housing !? some housings have gaskets between the base plate and housing , check the impellor in the housing and see if it stands proud as then you need the gasket ! compare with the old one as it mite have been forgotten !! check the seal and tube for the water pipe also ok!

Sep 23, 2013 | MERCURY / QUICKSILVER Mercury/Quicksilver...

1 Answer

Mercury elpto 90


Jun 27, 2013 | Boating

1 Answer

Flasher relay in a 98 mercury grand marquis?

The fuse block the relay is located in is behind the knee bolster, the trim panel under the steering column, left of the steering column underneath the dash. Common source of problems if that does not fix it is the Light Control Module ( LCM), turn signal switch unit, headlight switch.

Mar 08, 2013 | Mercury Grand Marquis Cars & Trucks

1 Answer

Tilt trim go up wont go down 2003 johnson 140 hp 4 stroke

You may want to check service bulletin #2002-052. Some of these motors supply too much voltage to the trim switch at the throttle lever and that trim switch stops working. There is an add-on harness #586806 that fixes this. If you can still tilt and trim the motor at the trim switch that is built into the motor housing this is likely the problem.

Jan 30, 2012 | Boating

1 Answer

Need to remove door panel on 2007 mercury mountaineer

  1. Disconnect negative battery cabe
  2. Carefully detach the door handle bezel
  3. Pry out the front edge of the armrest switch control plate and disconnect the electrical connectors then remove the retaining screw from the opening
  4. Remove the lower trim panel retaining screws
  5. Once all the screws are removed grasp the trim panel at the switch opening and pull it up and out.Disconnect the power mirror electrical connector

Aug 10, 2009 | 2005 Mercury Mountaineer

1 Answer

Power windows does not work in my 2002 moutaineer there is no other electrical problems how do I fix this

If they all don't work and you checked the fuse and it's good it is the window switch. Pretty easy fix, get a door panel tool at a parts store, unscrew all of the screws for the door pull, door handle cover, and what ever else is screwed on. Use the door panel tool to pop off the cover and the switch will then be accessible.

Apr 19, 2009 | Mercury Mountaineer Cars & Trucks

1 Answer

Handle broke off sliding door on drivers side 2000 mercury villag

Trim Panel —Sliding Door
Special Tool(s) syv~us~en~file=st1181a.gif~gen~ref.gif Safety Belt Bolt Bit (Used for T-50 Head Bolt)
501-010 (T77L-2100-A) Removal
  1. Remove the sliding door trim panel finish panel.
  1. Remove the sliding door trim panel.

Apr 13, 2009 | 2000 Mercury Villager

2 Answers

Mercury Cougar heater blower only works on high.

remove the trim panel below the glove box and you will see the blower motor,just to the left of it you will see a 4 wire connector plugged into the case. This is the blower motor resistor,this is what you need to replace.

Feb 12, 2009 | 1999 Mercury Villager

Not finding what you are looking for?
Boating Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Boating Experts


Level 3 Expert

694 Answers

ray gallant

Level 3 Expert

46437 Answers

Fabrice Wolters

Level 2 Expert

321 Answers

Are you a Boating Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides