Everytime i want to play Ac3 it say to eject the disc and to clean it and every 1 second it say it again

Try a CD Cleaning Disc. There are two laser optics in your CD changer, a low power tracking optic and a high power reading optic. If the reading optic gets dusty, the light becomes refracted, and the read fails and stops play or ejects the disc. The discs are available on Amazon, Best Buy, and Walmart for less the $15. Do two cleans and it should fix it.

https://www.google.com/search?q=cd+cleaning+disc

..

Car CD Players get dusty from road grime. Buy a CD Cleaning Disc and run it is a couple of times. The laser that reads the tracks is much lower power, and if it can't read the whole tracking system, it ejects the CD. The cleaning disc has little brushes that cleans the optic lenses.

https://www.google.com/search?q=CD+Cleaning+Disc

..

You can clean the lens with a small amount of windex and put a little oil like 3 and 1 oil on the spindle motor shaft and on the sled rails. Good luck !

I had the same problem. Take the top off and wind the loading wheel until the mechanism engages and loads - but with no disc in place. Then unplug the power and look through the top. You will see the lens. Clean with rubbing alcohol and a q tipi and dry with a clean q tip. Try playing a disc

To solve this error :

Never eject disc while game is in use.
Delete all your messages.
If playing a game on disc, clean the disc off and ensure disc is inserted properly.
Upgrade your firmware to the latest version.
Under Game settings, set PS/PS2 Upscaler to Off.
Restart your Playstation 3 and try again.
If all else fails, the disc might be defective.

Turn the Wii off and on again after about 20 seconds. Press the eject button again.

Unplug the Wii's AC power supply if Step 1 doesn't work. Wait 1 to 2 minutes, and trying to eject the disc again after turning the Wii back on.

Hold down the eject button for 5 to 10 seconds

Try ejecting the disc with the Wii at different angles. If you hold the Wii upside down, it may help the disc fall out.

Call Nintendo and send the Wii back if non of these steps work. In most cases, a disc stuck in the Wii should be covered by warranty.

Nintendo says to see if power light was coming on, AC adapter reset. unplug from both ends for 90 seconds.Hold eject button for five or 10 seconds.

Fiend your solution direct from nintendo. Here is your solution....


http://www.nintendo.com/wiiconsole/prob676ijt65/solution
145

I have had the same problem a few times. All I do is eject and re-insert the disk until it recognises it, this seemed to work for me

Hi Rick

The unit has stopped reading discs. I suggest taking the lid off and cleaning the laser lens with a cotton bud with a little Windex , then give it a gentle polish to be sure no residue smearing is left. If that does not fix it, check to see what actually happens when you load a disc. Does the transport fully engage and clamp the disc correct into the chucking assembly. Let me know how you got on:)

regards
Graeme

not come across this b4 try some1 elses dvd rom in your unit m8 first dont sound like a board default