Question about Office Equipment & Supplies
transfer belt issue. Motor issue.
Posted on Nov 12, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
press utility. press metercount. press metercount details. press stop 0 0 stop 0 1 to access service mode in service mode look for admin initialialation function
Posted on May 22, 2008
First check the alignment front and rear of the finisher, check the finisher exit guide rollers if the paper is exiting properly, open both rear and the front cover and check the lower gears attach is the up/down drive belt. that lower gear one might be broken by the pin slot.
Posted on Jul 09, 2009
this is a waste toner box error the waste toner box could be defective or the full sensor is defective i would start with replacing the waste toner box and clean the sensors on the door with some canned air the waste box and the sensors are located inside the lower front door the instructions on how to remove the waste box are on a label on the inside of the door
Posted on Dec 02, 2009
Tips for a great answer:
Jan 18, 2018 | Konica Minolta Office Equipment & Supplies
Mar 13, 2017 | Konica Minolta Office Equipment & Supplies
Nov 22, 2016 | Konica Minolta Bizhub C451 Copy-print-scan
Sep 14, 2016 | Konica Minolta C451
May 12, 2016 | Konica Minolta Bizhub C451...
Sep 21, 2014 | Konica Minolta bizhub Office Equipment &...
271 people viewed this question
Usually answered in minutes!