How do I reset all codes?

le code on washer indicate washer over load putting a stange on washer motor .performing a reset on washer will normally resolve this error, if the motor still lock up maybe need replace motor

I think you unplug unit, then hold in power button for several seconds and then plug it back in.

The LE code indicates a motor overload. The washer will not spin to avoid damaging the unit. First unplug the washer and let the motor cool for 30 minutes. When you plug in the washer, check if the unit has been reset.

The error often occurs if you use a non-HE detergent or too much detergent. In that case, do a Rinse and drain steps. Set the Spin Speed to No Spin by pressing that key several times. When that finishes, open the door and remove all of the clothes in the tub. Close the door and set the washer to Rinse and Spin. Run this program several times until you see no suds in the wash tub. If the LE code returns when the washer is empty, check the drain pump and filter for foreign objects. The error can also occur if you wash too many items at once or too heavy a set of items. Try doing a smaller load in the future.

If the error persists, then the tub motor, bearings, motor shaft or wiring may be damaged. Here is the parts diagram and one vendor's list of the replacement parts: http://www.searspartsdirect.com/lg-washer-parts/model-WM1814CW/3204/0153200/K0810333/00002.html . If your washer is under warranty, contact LG.

I hope this helps.

Cindy Wells

Check the harness from the ccu .If all in tacked replaced the ccu.

Hi Kimberly - If you are receiving an error code E41, it typically indicates that the loading door may be ajar. Double-check to ensure that it is securely closing. If it is secure, and since the unit was unplug for several hours, but the issue continues, then the door switch assembly or your unit's main control board is generally the primary issue. I would personally contact a professional to accurately diagnose the washer to determine the root cause to reduce the risk of unnecessary parts.

Hi,The timer is going bad...

That is not that hard to fix and you can easily buy the parts yourselfonline...

Here is a tip that will help you with the online buying...

How to Buy Appliance Parts Online

Here is one site that I recommendhttp://ping.fm/zJDAM
heatman101

we have a kenmore HE2 Plus washer, front loader. been getting F28 code for last several months. usually we can push cancel button, and it clears, unlocks the door, we restart and complete the wash. But now it is locked and we can;t clear it. have even unplugged the machine over night, it still will not reset. any ideas?

You're problem is probably the door latch assembly. This is a common problem on Frigidaire front load washers. You can find the part at your local appliance parts suppliers. If the door latch assembly is faulty, the washer will run through all of its normal cycles, but will not spin. Hope this fixes the problem for you.

Wow! Amazing that it seemed to run fine 'til that tank of regular. Good u checked the codes as suggested, did the check engine light ever go on? Glad it's ok, and thanks for the update!

We have not heard back on this in about a week. I'm presuming It's been repaired?