I have an RCA projection TV, model D52W19B. The TV powers on ok, stays on, and audio is normal. I don't get a picture. If I press the menu button, the menu will appear on the screen normally.

Make sure you resolder the flyback and recheck any RCA fuses that may be blown - they are usually near the flyback. If this does not help check the site www.tvrepairkits.com for repair kits or tips for your projection tv model.

Try this -

1. Press menu for main menu.
2. Press CH + or CH - to highlight preferences.
3. Press "OK" to enter preferences submenu.
4. Press CH + or CH - to high light "FPA"
5. Press VOL + or VOL - to turn the FPA on or off.
6. Press MENU repeatedly to exit.
7. Back to normal

• FPA stands for Front Panel Lock. It makes it so kids don't push all the buttons on the front of your TV. The power button on the TV will still work and the remote will still function as normal.

Regards, Tony

I have the same problem with the same tv.
did you get any solution?

The deflection board will most likely need replacement. You can get replacement boards from www.tvrepairworld.com for your model.

try unplugging the tv for a few hours. then plug it in and push the power button on the front of the tv.

it has something to do with this processor issue inside the tv....its pretty much a stupid thing.

should have been a recall because everyone has the same problem on here.

this is pretty much just a band-aid over cancer, but i've been having to do this for about a month now, and it works.

Ok so the sound is fine on all of the other sources,
The component is running from the cable box to the amp, and you can see it.
just take the audio Red/Whit RCA out of the cable box, and input it to Cable/TV or whatever its labled, Red White, RCA.

If you want surround, then you will have to go Coaxial((single orange RCA) or TOS out of the cable box to the Digital input on the AMP. When you use this instead of Red White RCA, your amp will automatically switch between the different types of surround depending on what the source calls for or is encoded in.

You may have to get into the amps menu and change that amps input to Digital/Coax/TOS for the surround sound.

Any more specific questions, I need the model #s.

you need flyback 259296 you can get one at the following link and they provide free online tech support to help you install it. Heres the link.
http://servicemanuals.vstore.ca/

Is the DVD player connected to the TV via component cables? If so you should have 5 connectors total that will bring picture and audio information to the TV.

I had this happen to mine and I had to have the high voltage transformer replaced. I took it all apart my self to save money and it only cost me about $285

Right now i have two of theses sets in my shop and what i am finding out is they have big problems with bad flybacks and high voltage tripplers.both of these set have now shut down and will not come back on so how much is all these parts ,will post that when i find out!