What dose the NF means

I believe you have a Samsung washer. NF means that the washer is not filling with water. Please check if the water supply faucets are opened.

Symbol - 'Washer has tried to fill' Check water faucets & hoses for kinks. OR call Maytag 1-800-688-9900. Happy Washing!!!!

Samsung Washer Error Code NF (Fixed ...

www.appliancerepairlesson.com/.../samsung-washer-error-code-nf-fixed/

Jan 11, 2014 - What does the error code NF mean on a Samsung washer? ... You can set the washer to any cycle and test each solenoid for proper voltage. ... Next would be to check the screens on the back where the water hoses connect. ..... Hi, you don'thave any power to the water valve wires when it should be filling?

No fill error. The washer thinks it's taking too long to fill up with water

NF stands for no fill, which means you are not getting any water into the machine. This is either because the water valve has failed or is clogged, the water is turned off or the pressure switch thinks there is already water in the machine but the last is very unlikely.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_4570d45317834dd3

nf means no fill the inlet valves would need to be replaced

Hello

NF error in your Maytag is displayed due to no fill condition, when the washer tries to fill but is unable to nf is displayed. Please check the water inlet valve for any clogs and obstructions, you can also clean the inlet to solve the issue. Please get back to me if you have any other questions.

Kevin

"nf" means you have a bad water valve . You may also have a bad hose underneath the lid .So check for them and replace if necessary

NF = Not Full
Is displayed when machine does not fill with water in the allowed time. Could be low water pressure at the feed pipe. Could be dirt clogging the inlet hose screen. Could be that the faucet valve is not fully opened.
Let us know of your success!!

if water flow is OK from the supply, remove the top cover and check the pressure hose that runs from the tub to the pressure sensor. They have a tendency to come loose on these machines. That is what my problem was...Always unplug power before removing covers...