How doi clear a program from my zodiac rs8 controller panel

On the zodiac jandy web site

go to system set up erase all programs if not able to clear memory make sure to write down all auxs

Unfortunately the disk is what actually makes it move. so it doies need to be replaced and most pool store outlets can get them or have them.

The circuit internally have gone short.There are many other facing this same problem.Some have got this indoor panel dead due to moisture collected on the indoor panels circuit board.The panel is not very strong to handle the humidity effect.It gets short. It has to be replaced. To get any other part and also the indoor panel board please click on the link below http://poolparts2u.com/products.asp?catid=0&scatid=27 ------ Thanks.

www.polytecpools.com/jandy-aqualink-rs8-all-button-pool-and-spa-combination-control-system-p-275.html -

To clear the memory
Push the menu button once
Push the back arrow to "System setup"
Push star * or enter button
Push back arrow till display says " clear memory "
Push star or enter
Push star or enter again to confirm.
You will get a message "erasing memory"
Now you can reprogram system