Mitsubishi pajero GH-V75W,6G74 I put a new crank sensor but still no sparks comming and car wont start at all is there any devices gives out sparks without the crank sensor.

I don't think there is a pump, it is done with engine oil pressure at the injector.

Have you tested the ignition module?

check out the coil , sometimes the high tension terminal spark will jump to the low tension terminal and short out.

if you got no spark to the plug, you just about have to have an engine light on your dash. go to auto zone or advance auto if possible to have engine error code read. a ton of things can give no spark.. isit to all plugs or just one? if all are bad, follow the spark plug wires back to the distributor, sheck the distributor cap for wear, by removing it and looking at the posts.. re[placeing he distributor cap alot of times cures the problem.

first make ur car battery fully charged,
then make sure to connect battery terminals finally and use a best plugs for ur pajero and then u will see hope fully car will start

run the fault codes to check for cam/crank position sensors ( possible broken timing belt). check operation of the immobiliser system --flat fob battery

Got Mitsubishi challenger 6g74 there is no spark, changed the crank and cam sensor, fuel is coming but still no spark. please help

Did you erased the code manually or the code clear itself?

It should be on the cyllinder block just below the head

Try changing the fuel filter , Sounds like its loosing fuel pressure.
If it still does it after that get the fuel pump tested.
Hope this helps