Question about Electrical Supplies

1 Answer

I have a new EU2000i companion the idles goes up and down when the echo throttle is on runs fine when echo throttle is in the off position

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

YOUR IDLE SPEED SETTING IS OUT OF SPEC.IT SHOULD BE ABOUT 1750 RPM AND YOU ADJUST IT BY A PHILIPS SCREW ON TOP OF THE CARB

Posted on Sep 10, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a deep eu2000i inverter, the problem is to remove the carburetor throttle, it takes some kind of setting as to start the engine low speed, and connect a tool fails ....


if your question is that my Honda generator wont idle up when I connect a load (tool) and it stalls then . first see if unit will run on constant setting (switch on front) if nothing or still barely runs or stalls , then your problem is carb or fuel filter (inside tank) one or both is most likely dirty and needs replaced/cleaned

Oct 15, 2016 | Honda EU2000i Companion Inverter Generator...

1 Answer

How do i fix a 2003 toyota echo showing trouble code p0511


Could be a wiring problem or throttle position sensor or the DC motor that controls the throttle position. P0511 Toyota Idle Control System Malfunction

Dec 18, 2014 | 2003 Toyota ECHO

1 Answer

What do I check? i have a honda eu2000i that starts and runs but no generator power


The internal monitor is sensing a load does a load make it change tone? Check the 12 v output and see if it is loaded.

Kevin H

Sep 08, 2014 | Honda Eu2000i 2000w Generator

1 Answer

Echo pb 255 throttle cable attachment


try parts tree .com they have decent diagrams..

Aug 27, 2014 | Echo Power Blower PB-255

1 Answer

Poor idling


Coils,fuel filter,dirty throttle body.

May 11, 2013 | Cars & Trucks

1 Answer

Have a PB-250, ran great but now only runs full throttle, does not idle low.


You've been running the unit with the wrong oil to gas ratio and now the unit runs rich - there is no real way to fix it at this point - you can adjust the carb but it will not probably hold the idle you desire - but then again blowers are to be ran wide open 85% of the time so don't sweat it too much on this unit but practice better maintenance and a proper mix ratio in the future.

Oct 05, 2012 | Echo PB-250, Handheld Blower,

1 Answer

VEHICLES STARTS BUT GOES OFF IMMEDIATELY. iF GAS


The throttle position sensor responds to the accelerator pedal movement. This sensor is a kind of potentiometer which transforms the throttle position into output voltage and emits the voltage signal to the ECM. In addition, the sensor detects the opening and closing speed of the throttle valve and feeds the voltage signal to the ECM. Idle position of the throttle valve is determined by the ECM receiving the signal from the throttle position sensor. This one controls engine operation such as fuel cut, etc. The throttle position sensor unit has a built-in “wide open and closed throttle position switch,” which is not used to control the engine. For the G35, the throttle position sensor is part of the throttle control actuator.

Jun 08, 2010 | 2004 Infiniti G35 Sport Coupe

2 Answers

Eu2000i lopes while idling. If i slide the choke


This is NOT uncommon when no load is on the units.

The "gain" of the govenor is designed for maintaining speed under load and will "hunt" a bit without a load on the unit.

Apr 02, 2010 | Electrical Supplies

Not finding what you are looking for?
Electrical Supplies Logo

Related Topics:

260 people viewed this question

Ask a Question

Usually answered in minutes!

Top Electrical Supplies Experts

Steve

Level 3 Expert

3287 Answers

Gene Haynes

Level 3 Expert

5089 Answers

Brad Brown

Level 3 Expert

15557 Answers

Are you an Electrical Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...