Question about Minolta Office Equipment & Supplies
My printer is Konica Minolta bizhub C-1180 what is error code C-1180?
What is the model? Bizhub 180???? with a C-1180 error code could not find that code in service manual, please check again
Posted on Dec 28, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
there are two ways you can rea\set the ip address you can press utility counter administrator password is 12345678 the go to network ip address and you can chane it there if you know the ip address you can browse to the machine and log in as administrator and go to network and reset there
Posted on Aug 22, 2009
SOURCE: Just received a Minolta Bizhub
Check if you have your optic mirrors clean, as well as the lamp and the CCD lens.The CCD couldn't read the white stripe at power up.
Other possible causes:
- Optics motor
- Bind on any paper tray lift (try the machine with the trays open and close them one at a time if the error disappears)
- Look for a pinched wire in the registration unit.
If not solved please call the Minolta Bizhub customer care.
This error code actually occurs only if there is a problem related to the optics.
post a comment for further assistance.
thank you for using fixya have a nice day:-)
Posted on Aug 27, 2010
SOURCE: I am using a konica
Press this button in same order and sequence
Where 0 mean zero of keypad then you see the msg "service mode" press down key and go to ADJUST and press OK press down key and go to ATDC and press OK check the value and increase some higher point again press OK press reset switch off and after some seconds switch on perform above actions until you get machine in ok condition or other otherwise you must be change the developer powder. but be sure to run atdc auto adjustment which is in SERVICE MODE-FUNCTION-ATDC AUTO ADJUST then press ok and leave the machine for complication his process,
Posted on Jan 27, 2011
Tips for a great answer:
Mar 15, 2017 | Konica Minolta Office Equipment & Supplies
Oct 03, 2016 | Konica Minolta bizhub Office Equipment &...
Apr 14, 2015 | Konica Minolta bizhub 350 All-In-One Laser...
Feb 17, 2015 | Konica Minolta bizhub Office Equipment &...
Mar 09, 2013 | Konica Minolta Office Equipment & Supplies
Jun 30, 2010 | Konica Minolta bizhub C250 All-In-One...
Nov 11, 2009 | Konica Minolta bizhub 350 All-In-One Laser...
Jun 23, 2018 | Minolta Office Equipment & Supplies
389 people viewed this question
Usually answered in minutes!