Question about Panasonic PT-47WX51 47" Rear Projection Television

2 Answers

Back screen lights are out of sync

Yellow, red etc. are not lined up on screen.

is there an easy way to realign them?

Posted by on

2 Answers

Re: back screen lights are out of sync

I have a PT-50DL54J that was like that. I popped off the plastic cover below the screen and it unveiled two things. The bulb that I will someday have to change, and a way to focus the colors. There are two silver screws in the removable center plate, take them out, vacuum out the dust..then look for a silver hand screw on the right side. Loosen it just slightly, don't remove it. Turn on the tv and slide that screw up and down until you have it focused.

Posted on Jul 14, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers
Re: back screen lights are out of sync

This projection TV is made up of 3 projectors R G and B (Red,Green,Blue) These colors mix to create the other colors all you have to do is both convergences

Posted on Jun 02, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

When i go to turn on the tv the red power light turns on and then starts flashing, with an all blank tv screen. I cant get anything but a black screen. The light will flash for a lil while, then the tv...


1. Unplug set for a few minutes.

2. Plug back in and turn on.

3. When red power light starts blinking--COUNT THE BLINKS.

4. THREE BLINKS, pause, THREE BLINKS (ETC) IS SHORT PROTECTION AND A DO IT YOURSELF repair for some people. I have complete instructions for this repair.

5. 5 blinks, pause and 5 blinks etc is short on 140 volt line and while not as easy as 3 blink error code it points to places to look at.

If this told you something you did not know, rate this solution as very helpful as I do this here for free.

Post a comment here when you know what error code is and I will help.


Aug 16, 2010 | Panasonic PT-47WX53 47" Rear Projection...

1 Answer

Distorted picture

You have a convergence problem.On this model you can change the convergence amp board which has the convergence IC's on it making it an easy repair.

Oct 06, 2007 | Samsung HC-P4752W 47" Rear Projection...

3 Answers

KDS50A2000 Green light comes on briefly followed by red blinking light. 4 on then pause, etc. etc. Problem???

I tried this solution last night. had a similar issue. opened up the back panel and cleaned the fan. just for the fun of it, i tried to turn the tv on and presto. it works fine now and i probably saved a bundle. thanks!!!

Jan 25, 2010 | Sony KDS-50A2000 50" HDTV

1 Answer

Yellow, blue and green ghosting of picture. Convergence mode will not allow realignment of the red and blue lines

Hi,it sounds like a light engine problem.Lcd Technology uses 3 chips blue,green and red that create the image ,when they start to fail color discoloration will occur.If it's an Dlp pay attention to sounds of buzzing,whirling and high pitch sounds because it could be your colro wheel.

Oct 05, 2009 | Mitsubishi WS-55511 55" Rear Projection...

1 Answer

Red blue and green not lined up

56 inch panasonic tv has blue yellow lines running up and down on right side

Apr 09, 2009 | Panasonic PT-56WXF95 56" Rear Projection...

1 Answer

Alinement of blue cross with red and yellow.

you will need to call someone in to realign the picture...

Feb 16, 2009 | Pioneer SD-532HD5 53" Rear Projection...

1 Answer

Color is mostly yellow and blue with double images

you have lost the convergence IC`s in your set, this really isn`t a diy repair unless you are very proficient in un-soldering and re-soldering components, once replaced there will be an alignment procedure as well that will require the service manual also, if you have more questions feel free to ask away, video-tek

Feb 04, 2009 | Hitachi 53UDX10B 53" Rear Projection...

1 Answer

Toshiba TP50G50 Theaterview picture is double with red color only

Your alignment is off. Go to the set up menu then convergence. hit right and you will be in the convergence menu. select the color that is not in alignment. The green line does not move. if blue and green are lined up the line will be cyan. if red and green are lined up the line will be yellow. when all three are lined up the color will be light. Best of luck!

Nov 16, 2008 | Toshiba TP50G50 50" Rear Projection...

1 Answer

Blurry, Multi-Color, Multi-Line

covergence problems and its not adjustable you need work done on the convergence board or a new board and realignment which can be timely.

Nov 01, 2008 | Samsung DLP HL-P4663W 46" Rear Projection...

3 Answers

How to adjust picture on projection tv

i have a 52" rca projection , and the screen looks like this ") (" on the sides can i do something to straiten it back out?

Aug 28, 2007 | Panasonic PT-53TW53 53" Rear Projection...

Not finding what you are looking for?
Panasonic PT-47WX51 47" Rear Projection Television Logo

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Panasonic Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

Josh Whitehead
Josh Whitehead

Level 3 Expert

1142 Answers

The Knight
The Knight

Level 3 Expert

66623 Answers

Are you a Panasonic Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides