Question about Admiral AAV7000A

1 Answer

Admiral AAV8000AWW washer - clothes are wet after spin cycle...

Clothes are very wet/damp after the spin cycle completes. Drum spins, washer is level and drain is not restricted. Water appears to drain out, but not sufficient spin speed or sunction to extract the water. Thanks.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.


    An expert that has over 500 points.

  • Expert
  • 351 Answers
Re: Admiral AAV8000AWW washer - clothes are wet after...

May be a loose belt or a partial blockage somwhere.

Posted on Mar 08, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

2 Answers

My washer/dryer combo Frigidaire washer dosn't spin water out of clothes completely after spin cycles the clothes is still very wet. On the 1st spin cycle drum dosn't spin just makes noise,the 2nd and...

Good Afternoon Friend,

I understand your Frigidaire laundry center, model# FGX831CS, is not spinning water out of your clothes completely. I see that on the first spin cycle the drum is not spinning and is just making noise, and on the second spin cycle the drum spins to the left very slowly and loudly. First check to see if your washer is overloaded. Try taking some clothes out and spinning them again. Secondly, make sure that the load is not out of balance. Try rearranging the clothes to allow for proper spinning. I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if your dryer status has changed successfully. Hope this is helpful.

-Best Regards-

May 19, 2014 | Frigidaire FGX831CS Top Load Stacked...

1 Answer

Clothes are wet after spin cycle

U need a technician for that... there is a problem with the "flow valve" sorry can't help u out much with that... but maybe u can visit this site and hit the like button...

Jan 13, 2014 | Amana 3.2 cu. ft. Top-Load Washer

1 Answer


are you sure that its spinning as this is a common problem with wet clothes. When the cycle is complete the clothes should be wrapped around the bottom of tub not just lying there,

Sep 26, 2011 | Admiral AW22 Top Load Washer

3 Answers

The washer is not spinning well...Clothes are partly wet when cycle is completely used also to leak at one time where we can see some water when the cycle is complete...

Hello, when the clothes are partly wet when cycle is complete then check these.
1. Motor coupler
2. Spin cycle

MOTOR COUPLER; To test the motor coupler, restart the washer in it's spin cycle,let the machine runs for a minutes and then open the lid and notice if the tub is spinning: if it's spinning when you lift the lid that means the coupler is fine and if it doesn't spin that means you have to replace it.
SPIN CYCLE: If the washer doesn't reach it's proper spin speed,the cloth may be wet at the end of the cycle,check to be if the load is properly balanced and run a spin cycle again,if the clothes are still wet, you may have a worn or loose belt which you have to replace.

Jun 10, 2010 | Maytag LAT3600A Top Load Washer

1 Answer

Kenmore Elite H3E Washer Drain/Spin Problem

it is the belt problem
check it///thank u
please rate it

Jul 04, 2009 | Washing Machines

1 Answer

Admiral washer, spins too slow so clothes are still soaked

The clothes being wet and the drum spinning slow are probably due to a worn belt, tilt the machine back and the belt can be removed and replaced from below with no tools.

If the machine is constantly filling with water the level pressure switch requires changing. Isolate the machine, use a knife or thin bladed tool and insert between the front panel and the top panel approx 4" from each side to release the clips, the top should lift up, the pressure switch i at the back LH side, you will see a small pipe attached to it from lower down the drum, replace the pressure switch pull off the terminals and the hose and replace using the same order of connections.

Apr 14, 2009 | Admiral AW22 Top Load Washer

1 Answer

Washer spin cycle

Dear Friend,
ngfam1 here for you!
I am happy to be of assistance!

If it's reduced from hoe it used to do it, then you must call service before there is any more damage.
Some washers can leave the clothes damp or slightly wet but not dripping!!!!!!!!!! Thats a malfunction!!

Here is a good service that I recommend to my customers,
in our 65 year old appliance business!

A&E Factory Service
1-800-905-9505 -(IN U.S.A.)
They are open to make appointments 7days/24hours
A&E is factory authorized service for most brands!
Including warranty work!!!
They will help you, and all will be well!

Good luck!
You will be fine now!

Thank You
Bless you,ngfam1
PS. Please give me a good rating here in before you sign out!

Jul 22, 2008 | Admiral AW22 Top Load Washer

Not finding what you are looking for?
Admiral AAV7000A Logo

1,038 people viewed this question

Ask a Question

Usually answered in minutes!

Top Admiral Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Brad Brown

Level 3 Expert

13362 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Are you an Admiral Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides