<!-- from fixya rte -->Projector cutting off on right size - Epson Office Equipment & Supplies

I would suggest it's probably a screen resolution an older laptop VGA output was probably 800x600. The projector will also have a recommended and maximum resolution. The newer laptop will have a much higher resolution. You will need to adjust the laptop's video resolution to the optimum projector resolution

Hi Anonymous,

Most of the time, when an image is cut off the problem is coming from the source.

I assume you are using a computer connected to the projector? Try using different resolutions in your computer's settings. If you are using Windows, right click on your desktop (away from any icons) and go to screen resolution to make the changes.

I hope this helps!

Mendtronix
Projector Lamps Projector Bulbs Projector Parts Projector Repair Servcie

you can buy new pipe from any rubber line outlet comes in meters or yards etc. also there is plastic vacuum lines, these are 3-or-4mm thick. cut to size and fit to engine lines.

after you connect the laptop and the image shifts to the right, press auto adjust on the remote and the image will get OK.
If not try resetting the projector settings to factory [not the lamp settings]
this should solve the problem
if not change the main board

Better to take it back to the place where you bought it and get it looked at under warranty for free

Take the filter to the local electronics repair shop and ask them for some filter material like the one in the unit. Then cut it to size to fit like the old one.

Yes you can cut off you projection there is three ways to cut off.
1. there is a button on the projector name "SHUTTER" press the shutter to topping the projection temporary.
2. One same button on remote control "SHUTTER"
3. and the same function you can use with in menu of projector
press MENU button use LEFT and RIGHT arrow buttons to select "OPTION" press one time DOWN arrow button to select the SHUTTER press ENTER.
(for re-projection just press again SHUTTER button from remote control or projector key pad or through menu)

reset the settings to factory default. is it cut off evenly, or is it uneven and shadowed? if it is the latter and you have a dlp projector, you have a collapsed light tunnel. if it is cut off evenly, go into the settings and make sure the resolution and screen size matches.

Hi wspy

If the look right next to the holes there should be a screw size written on the casing itself.

Hi there

First take out the lamp and check for any signs of damage.

If you can't see anything check the Ballast ( Lamp's powersupply )