How to fix "Depleted cartridge to be replaced" error?

Canon Printer Error 5200 may occur if the ink level in your printer is low or if you have a defective ink cartridge. Follow the steps to fix Canon printer 5200 Error code:

·Refill your cartridges/Ink tank
·Clean printer cartridge
·Factory reset printer

Find here the more canon printer error codes and their solutions.

Hope this helps you...
https://www.youtube.com/watch?v=t2s8RsA6iF4

use only new cartidge. Its the best thing you can do if you want your printer work fine with no trouble.

The toner sensor needs to be replaced or at the very best you have toner spilled inside or a bad cartridge.

Hi Don,

Remove the Black cartridge and Clean the electrical contacts ( golden contacts ) with lint free cloth.

Turn off/on the printer and install the Cartridge. If this does not work, On the Front panel, Press Setup button >> Tools >> Clean Printhead/Cartridge - Press OK

This should fix the issue.
If the above steps did not fix, Replace the cartridge if its very old and has not been used for long time as it could be depleted. Try calling HP on 1-800-474-6836 If this is Genuine Cartridge recently purchased and it does not print in black.


Regards,
Sean

change cartridge.

Printers usually have two separate ink cartridges. Depending on the cartridge that is over exerted in print jobs is depleted faster than the remaining one. Open the ink compartment to ascertain the ink models to make possible acquisition for replacement from retail. Ink acquisitions may require verification for the appropriate models and brands. Extracting the depleted ink cartridge as reference comparison at retail enables appropriate ink selections compatible with the printer.

There is a chip on your cartridge that communicates with the printer to estimate how much ink is left in the cartridge. When the chip thinks the cartridge is empty it will refuse to print any more pages no matter how much ink is left in the cartridge. These cartridges are only estimated to print "up to 840 4" x 6" photos, or 80 13" x 19" photos." If it showed half full yesterday and then you put through a large print job it is very likely the cartridge is empty. In any case once the chip thinks it's empty the cartridge needs to be replaced.

I had this problem recently after replacing the yellow ink cartridge. After much wrangling with HP, they sent me a new cartridge (since it's date code was not expired) and that seemed to fix that particular issue. You might also try getting a replacement cartridge from the vendor that sold you the one in question since it's likely to be faster and less painful than going to HP directly.

Both of the cartridges did need replacing; the black is OK now so just pop in a cyan and you should be fine.