Question about Maytag Neptune MDE5500AY Electric Dryer

Open Question

Why does my Maytag Neptune dryer flash something that looks like E5?

Is there something we can do without having to call in a repairman? My repairman is on vacation until August 30.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 262 Answers

SOURCE: Maytag Neptune Dryer

is the drum light on while the door is closed?? look on the teck sheet found in the lower front panel for a wiring diagram momery servers me there is a thermal fuse chances are this is bad if you cant find this tech sheet I will look in my invoice book and see if I can find the sheet for it good luck let me know what you find out

Posted on Jan 17, 2008

Ad

SOURCE: Maytag neptune dryer won't start

Hey all neptune stricken owners - I removed the circuit board which was darkened substantially in the resistor area, but the maytag repairman got no money this time!! . . . And the cold is no longer the problem it has been for the past couple of years. We replaced the 3 main capacitors(blue) and the cluster of four resistors(brown) - and voila - the dryer works like new!!! It only cost a few bucks ($.67, $.92 etc etc) as opposed to the $151 a new board was going to cost!

Posted on Jan 20, 2008

frankgant
  • 250 Answers

SOURCE: Maytag Neptune dryer timer won't stop

If the timer is not stopping as it goes around then it's for sure the timer. The timer does pretty much all the work with controlling the dryer. And if it's physically not stopping going around then it has broken.

Posted on Jul 08, 2008

  • 2 Answers

SOURCE: Changing the drum rollers on a Maytag MDE4000AYW Neptune Dryer..

The instructions above are perfect for most Maytag Dryers, but the Neptune MDE4000AYW is built differently from most. To open it, undo the two screws that run through the door hinges, and remove the door, then undo the two other screws that are on the opposite side of the doorway. With these four screws out, you can lift the front panel UP and out. Make sure you unplug the dryer first :-)

Posted on Nov 21, 2008

  • 686 Answers

SOURCE: Maytag Neptune Dryer making vibrating noise while working

a bearing in the back for your drum sounds like what you describe. It needs to be taken apart and the bearing lubricated with high temp grease

Posted on Feb 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Obama vacation scam


Don't you have something better to do?

Jul 23, 2017 | The Computers & Internet

1 Answer

Hello, I have a GPS FURUNO GP31 and his screen is out of service and I want to retrieve the data. You can do this ? because I am on vacation until Saturday, August 2 sydney.or i go to melbourne until...


I have posted the Operator Manual at
http://www.offscotland.plus.com/Temp/GP30-GP35-Operator's_Manual.pdf

Use this to check out section 7-10 to make up a cable to connect to a PC to allow download of data. Then, using the manual as a reference figure out the sequence of buttons to press to get the GP31 to download the waypoint and route data to the PC. Just press the buttons and assume the display is showing the next prompt. If you know someone you has a working GP31 get them to do the sequence and write down the buttons they press. You just copy the same sequence. You will need some software on the PC to capture the data,

Jul 30, 2014 | Furuno GP31 GPS Receiver

1 Answer

Maytag neptune error message e5


This normally indicates that the thermistor is bad. Try measuring it to prove it is OK. It should be 10K Ohms at room temperature (20C / 68F).
If necessary, replace it then clear the error code.
1. Enter to Service Mode by press CHIME and TEMPERATURE keys for 3 seconds or until 3 beeps are heard.
2. Access Diagnostic Codes by pressing WRINKLE PREVENT. A d will be displayed. Rotate the CYCLE SELECTOR KNOB in either direction to read it.
3. Press SENSOR DRY and TIME keys for 3 seconds to clear it.
4. Power OFF to exit Service Mode
5. Power ON

Sep 06, 2012 | Maytag MDE9700AYW Neptune 174 Electric...

1 Answer

My Maytag Neptune dryer is still flashing the E5 code


I looked up and there is no E5 error code listed in the tech sheet.

Check it and confirm us.

Oct 13, 2011 | Maytag MDE9700AYW Neptune 174 Electric...

1 Answer

My dryer is still flashing the E5 code after I changed the themister


I looked up and there is no E5 error code listed in the tech sheet.

Check it and confirm us.

Oct 13, 2011 | Maytag Neptune MDE4000 Electric Dryer

1 Answer

Maytag neptune dryer has e5 error code


Hi,
I looked up your model and there is no E5 error code listed in the tech sheet.
Download a copy of your tech sheet here.
files.me.com/appliancejunk/e8bg66
When I search the maytag data base this is the service manual it list for your model number.
http://appliancedigest.com/index.php?/files/file/81-16023110-maytag-sloped-front-dryer-repair-service-manual/
If the dryer is running but not heating then the relay on the control, ignitor or thermistor are the most likely causes.

Aug 03, 2011 | Maytag Neptune MDG5500AW Gas Dryer

1 Answer

HP a6750f monitor goes to sleep without warning right in the middle of something. Disc also sleeps sometimes (I hear it wind down) but blue light still on cpu, no yellow. Was running Vista, which problem...


Well FIRST take it back and make that "Repairman" work on the problem until solved at NO extra fee. What has been done is NOT professional. Had you come to my shop, this wouldn't have happened and if it did, it would be remedied without cost, and would be worked upon until fixed. The same must apply here. You paid good money for a FIX NOT OS replacement I suspect you have a faulty component,maybe Video card maybe WiFi card etc. Please do NOT accept a run around. Try the "Honey"approach first, then "Vinegar"... if, you get any BS, from them/Him. I am sorry on behalf of us professionals.

Mar 07, 2010 | HP Pavilion a6750f PC PC Desktop

Not finding what you are looking for?
Maytag Neptune MDE5500AY Electric Dryer Logo

Related Topics:

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Maytag Dryers Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Archie Ferrarini
Archie Ferrarini

Level 3 Expert

869 Answers

Craig Butler
Craig Butler

Level 3 Expert

1730 Answers

Are you a Maytag Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...