CRT Monitor Stuck In Stand-By

Try to connect the monitor on other source for signal -laptop or other known working computer.if it posible.
Try with other rgb cable.Moust of monitor go tu stand by or power saving mode when is not presence of signal from computer(h-sync )
If monitor works ok on other source,than problem is in your computer(vga card probably)

If you mean you didn't get any display in your monitor the first solution is u must reinsert your memory and memory slot.if still have the same issue confirm your monitor is connected to your tower properly.if you still have the same issue just replace your memory (ram).thank you.

Hi.

If the Power Light blinks, its means that the monitor is in ' STAND BY Mode '.
Monitor stays in Stand-by mode only if it does not getting any signals from computer.
please check the cable which connects the monitor and computer are connected properly.
Also check that the cable is connected to the proper slot of the computer.

If you hear some continuous beeps when you start the computer, then the problem may with the display card ( Video Adapter or Graphics card ) on the PC.

thank you

Unplug all the Cables from Compaq Presario 5103 CL and leave the Keyboard, mouse and monitor cable pluged in.

Now make sure the power cable of the monitor should be pluged in and the power cable of the tower should be pluged in.

Now to check if the montor is fine just unplug the video cable only which will show no input signal on the screen. If it shows this signal the monitor is fine. Plug back in the video cable.

If the monitor is going to sleep mode it might be possible that the old computer ( Compaq Presario 5103 CL ) is in stand by mode. hit any key on the keyboard and it should come back .

If it is not in the stand by mode then do one thing. Check the same monitor with the new computer. If it is working. Perfect ..!

Do one thing now ..!

Unplug all the cables from your old system and then press the power button for 30 sec and let it go. Now plug the keyboard, mouse and the monitor try again.
If it works Perfect. If not ..!

Then you need to open the tower and check on the processor FAN is it running..? If its not running you will not get the display as the fan is responsible for the display on the screen. Otherwise...!

Check the Tower possibly the Tower is not getting the power.

Try these steps and let me know If it works

Please somebody give a solution as same is experienced by me tooo.

it could be th epower supply and it could be the monitor.
power ON button should not flash orange regardless what you do. it should stay green. then orange. not orange to green to orange.
try the monitor on another PC if you can fine one.
the other thing is are the 2 monitor similar (CRT to CRT and LCD to LCD), you can't mix the the two, they will work but need different video driver to function correctly.

for the hp x1907 we purchased recently there is no release it is just really hard to straighten, it has to be tight because you wouldn't want a wobbly stand

see i use Compaq too
they don't generally except other modes

did u try that monitor with other pc where it worked

u should install proper monitor software ... u will found it from the cd given wit Ur monitor

If still under warranty or if you have no electronic repair experience you should take the set back to the shop or to a repair person. Some of the solutions described below can be dangerous, TV's are very hazardous to service. Even when plugged out, TV's can store very high voltages. May need to check the caps in the G-2 supply circuit. Also you may have a CRT going flakey. Just a slight G2 level adjustment may suffice also. Good luck