Question about Lakewood HV-12-c Floor / Box Fan

1 Answer

It seems like no power is going to the fan. it is completely dead when turned on

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 136 Answers

Fan is pretty simple, plug, cord, switch or motor. You can check the 1st 3 with an ohm meter. Just check for continuity, seeing if the different parts are good. If all are good, need new motor, or replace fan.

Posted on Jul 01, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Have a kenmore he4 front load gas dryer. It would go completely dead like it had no power... intermittedly working... we replaced the control board. Seems to come on fine now however the end of cyc

is the dryer sensing strips clean? Could be some dryer sheet goopus on them causing intermittent sensing to clothes?

If you need further help, reach me via phone at

Jun 28, 2017 | Dryers

1 Answer


Possibley a short in the wiring to the fan, i would check the underhood fuse box for a relay or fuse to remove so as to save the charge of the battery until you can isolate the issue. Water intrusion in the front frame area is typical.

Mar 24, 2012 | 2002 Chevrolet Cavalier Coupe

1 Answer

We have a Sony VAIO, VGC-LV290J. When plugged into an outlet, the machine's fan just revs. The "VAIO" splash screen does not appear and the screen remains blank. The Bluetooth keyboard does...

It seems that the 'POST' (Power On Self Test) is not starting, and thus is not displaying the "splash" screen. The fans will run at 100% until the POST completes.
But, if the POST does not complete, the fans will "roar".

Check for a defective CPU, or defective RAM, or a defective motherboard.

It probably is *NOT* the CMOS battery -- if that battery is dead, then the "default" settings should allow the computer to start (with the wrong date/time).

Mar 15, 2011 | Computers & Internet

1 Answer

My PC kept getting this black screen saying something about rebooting so I tried several times but it didn't seem to work right. I turned off the PC and unplugged it from the back. I plugged it back in and...

a1240n (desktop)
the fans are dead. right? why not start with sounds.?
Desktops have 2 or 3 fans
1 in the PSU that must run fast,. does it ,heard and seen?
2: the CPU, has fan for sure, and must spin, blow air across the CPU heat sink not packed full of lint all PC this old ,always have,
3:then the GPU video card may have a fan that again must work.
so if all fans are dead, the psU IS BAD,


answering for
dead PC
dead black screens, never any text.
no sounds from PC
no monitor stated(i'd need that if the PC made sounds)

Jan 23, 2018 | HP Pavilion a1240n (EG136AA) PC Desktop

1 Answer

Lost power. Fan will not turn on.

Sounds like the fan controller may have fried. You may want to get online and contact the manufacturer.

Jun 08, 2010 | Hampton Bay 46056 Callaway II Ceiling Fan

2 Answers


could be the temp sensor for the coloing fan you have 2 one for the ecu and one for the fan

Jun 16, 2009 | 2005 Chrysler Town & Country

1 Answer

Turn key to start and nothing

Not if you left your headlights on all night and completely drained the battery. if it is dead, try to jump it, if you get some sort of power with the jumpers attached, go buy a new battery.

May 29, 2009 | 2001 Toyota Tacoma

1 Answer

No power getting to my Lakewood fan...

Maybe you tripped over it so hard you de soldered the wires form the inside. Have you openned it? Try it out if you didn't. Check the power cord and follow it all the way into the motor (with the motor openned). Check if one or both cables on the inside are desoldered.

May 09, 2009 | Lakewood HV 18-c Floor / Box Fan

2 Answers

Laptop does not power on !

first of all change ac cord and batter then try with the fan

May 16, 2008 | Acer Aspire 3004WLCi Notebook

Not finding what you are looking for?
Lakewood HV-12-c Floor / Box Fan Logo

Related Topics:

606 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lakewood Dryers Experts

Craig Butler
Craig Butler

Level 3 Expert

1723 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Jay Finke
Jay Finke

Level 3 Expert

1384 Answers

Are you a Lakewood Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides