Why do no lights come on when plugged in? - Mitel 5340 IP Phone

Please try this:
1) Make sure camera is OFF.
2) Plug Charger into the wall (not into camera)
3) Last think plug charger into the camera

check the relay for the g-plugs as it is not supplying power to the glo-plugs. Check that there is power getting to the relay to energise it to get power to the plugs.. Probably a fuse is blown

never seen one but if you look really hard im sure you will find the plug in it is most likley close to the power inlet these lights run off dc power converted from ac power there is a driver somewhere that has the plug in

Your diesel vehicle is equipped with glow plugs, and also with a Glow Plug Light that will either come on and stay on, or flash or blink when a fault is detected by the ECU (engine management unit). When the Glow Plug Light comes on, the ECU stores information about the condition that has caused it to come on.4 Jan 2016

Is It Safe to Drive With the Glow Plug Light On? ' YourMechanic Advice

https://www.yourmechanic.com/article/is-it-safe-to-drive-with-the-glow-plug-light-on Glow plug light wont go out Google Search

Dear Sir Glow plug light is on it didn't mean that glow plug faliuer, it mean the power supply is continusly on to glow plug, car will start good even incold condition,please check glow plug timer or show it technician ,but it can cause glow plug failuer in future. Thanks.

are they both on the same switch?
have you checked the bulb it self or the socket that it goes into?
have you checked the plug in the fixture for the light? plug the fan into the light socket plug to check and do the same for the light - plug into the fan outlet...
have you checked both the neutral and the hot for the light plug?

Hello philkatkiele: My name is Roger and I will help you. First thing you need to check is the glow plugs. They will need tested individually. Un plug all 8 glow plugs. Take a test light and hook end to the positive battery cable. Touch opposite end of test light to the terminal end of the glow plug. The test light should light. Touch all 8 glow plugs. Ant that do not light are bad and will need replaced. If glow plugs are burnt out then the controller will flash wait light to early or very fast. The wait light should be on for approximately 10 seconds.If al glow plugs check ok then I would suspect the glow plug controller as the problem. Also if the temperature out side is below 40 degrees the truck should be plugged in. This will help to make the engine start easier. Should you need further help please just ask.Please rate the answer as this way I know it was helpful. Thank You for using Fix Ya. Roger

Ask a friend and not a computer.

Could be a bad ground. Check the bulbs too.

the best way i have found to test glow plugs is to disconnect the wire to the plug and get you 12volt test light and put your negitive lead of the test light on the positive battery cable so when you touch the test light to any ground the light will light. so now go check your glow plugs and if you have one that doesnt light the light its burned out.
good luck