Question about Encore Software Kawasaki Jet Ski Watercraft for Windows

1 Answer

Sprung a hole in one of the components of my jet ski and it squirts water into my hull. It was running fine, i understand it is water cooled. When I went to flush the cooling water lines out with fresh water, I noticed water spraying out of a oblong green ''thing''. I'm not sure of the parts, trying to find a schematic online. It is a 1995 kawasaki jet ski.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,978 Answers

If you go to you can look up your own parts on the micro fiche and get the part numbers.

Posted on Sep 03, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Hi my name is Neal. I have a 2004 kaw 900 stx jet ski with the heat light flashing and when I put it in the water it will NOT run full throttle and cuts out from start. However out the water with flush...

I'm no expert on jet-skis or anything but it sounds like you may have a "water-pump" issue. In the water it bogs and cuts out..... but put a "flow" of water from a "hose" and it runs fine out the water, the flow of water surpasses the water-pump and allows flow to cool the engine. I would check water-pump before I would go too far with it. Hope this helps, Jesus loves you, John 3:16-17 (KJV)

Jul 18, 2018 | Cars & Trucks

1 Answer

Jet ski troubleshooting

kawasaki ultra 260's are only cooled by lake or sea water so if the water supply gets blocked then it will overheat ! did it definatly overheat or just loose power because the superchargers do sieze up due to damp air or the pully bearing , also the dipsticks on them sometimes shear off and lock the cogs ! does the engine still run up on a hose pipe ? also has the ski been left a long time not used without fogging the valves in the head ? this is my job so get back to me ( 30 yrs ) ..

Dec 28, 2013 | kawasaki 2010 Jet Ski Ultra 260X

1 Answer

Jet ski won't crank over in water but starts fine out of water

Is the bilge working properly or is their excess water in the hull could be causing a short

Mar 14, 2013 | Yamaha 12V Air Pump

1 Answer


I had a similar thing happen on a jet ski I was restoring. There was a mouse nest in the water box. Ran fine straight ahead but when you turned a corner it would block the passageway for the exhaust gases to escape the water box. The pressure builds up in the exhaust system and makes the motor shut down like it is flooded or out of gas whenever you turned a corner. Once you straighten the machine up the pressure escapes and it runs fine again. The bad news is you may have to pull the motor to get the water box out and clean it (Kawasaki). It just depends on the lay out in the hull. It may be a labor intensive fix but it can usually be done for just the cost of a couple of gaskets.

Jan 10, 2011 | Yamaha 12V Air Pump

1 Answer

1995 kawasaki 750 jet ski overheats when going fast

Check your plug color. You may be having a high speed mixture problem. Is your ski spitting water out the tiny hole on the side? You should try flushing the engine, you could have a motor full of sand if you beach the craft but do not wash the sand out of the back before starting. Also inspect the engine water tubes for cracks. From the hull to the motor and from the hull to the jet pump.

Aug 26, 2010 | kawasaki Full Suspension Mountain Bike Men

1 Answer

Kawasaki jet ski starter motor removal

To get access to the starter you will probably have to lift the motor out of the machine. Most Kawaski hulls do not give you much room to work. When you take the exhaust off you may have enough room to unbolt the starter.

Aug 24, 2010 | Encore Software Kawasaki Jet Ski...

1 Answer

How to replace seal on a jet ski

The seals in the drive pump can be replaced by taking off the ride plate and pump housing. To replace any other seals (engine or hull) you will have to remove the motor from the hull.

May 15, 2010 | kawasaki Full Suspension Mountain Bike Men

1 Answer

How to replace seal on a jet ski

If the seal is in the jet pump, get an impellor tool and replace all the seals and bearings in the jet pump. You will have to pull the engine to replace the crankcase seals or the rear hull seal.

Mar 27, 2010 | kawasaki Full Suspension Mountain Bike Men

2 Answers

I have a 2001 ultra 130 di jet ski and with two people on it that do not weigh much the jet ski will roll over at idle speed if you are not really carefull. Please help, it is a great jet ski for one...

Many hulls when turned sharply below planing speed will flip when riding two up. When wearing a neoprene suit you need to jump in periodically just to cool off. Make sure you have drained all the compartments in the hull of water every time you take the boat out of the water. I purchased a ski once that would not plane off and had a dry engine compartment. When I pulled the plug at the back several gallons of water came out. It made all the difference in the world losing all the ballast.

Oct 12, 2009 | kawasaki Full Suspension Mountain Bike Men

1 Answer

My 1997 polaris jet ski keeps taking in water? what could this be??

Unplugged water tube, cracked water tube, bad drive shaft hull seal, hole/crack in the hull, cracked water box, broken exhaust jacket water seal, water tubes plugged in incorrectly, no cap on flush kit, broken fitting on motor,etc. Dry out the boat take off the seat and place it in the water and look to see where the water is coming into the hull.

Sep 07, 2009 | Polaris ATV

Not finding what you are looking for?
Encore Software Kawasaki Jet Ski Watercraft for Windows Logo

Related Topics:

214 people viewed this question

Ask a Question

Usually answered in minutes!

Top Encore Software Video Game Consoles & Games Experts

James Wishart

Level 2 Expert

122 Answers


Level 3 Expert

81400 Answers

Brad Brown

Level 3 Expert

17446 Answers

Are you an Encore Software Video Game Console and Game Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides