Question about Dishwashers

2 Answers

Asko dishwasher model 1475

Five lights on front panel flashing,pumpis running machine will not shut off

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer
Re: asko dishwasher model 1475

Believe it or not that unit has a pressure switch like a washer attached to fill and pump out that is more like to be the problem.

Posted on Feb 16, 2010

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer
Re: asko dishwasher model 1475

Have the same problem with our asko 1475. In the past, we would disconnect the dishwasher and when we reconnected the power, it ran fine. This time it isn't helping!

Posted on Jul 12, 2008

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Start light flashing. Dishwasher wont start

I'm guessing as you did not list the model number. Something similar happened on mine. Due to a freeze, there was a small crack in the inlet and water had slowly leaked. As a safety feature, the Asko has a tray under the dishwasher inside the overall dimensions. It has a float. When the float rises, the drain pump starts and the dishwasher will not start. In my case, the drip pan is not connected to the drain which gave me the drain sound, but did nothing to remove the leaky water.

I suggest you take the front bottom panel off the dishwasher and check for water/leaks.

Oct 29, 2014 | Asko 24 in. D3121XL Free-standing...

1 Answer

Front top panel broken on ASKO model 1375 where can i get a replacement

Parts of that type might be hard to get for this model.

Try this site and select the part based on your dishwasher finish.

Apr 01, 2014 | Asko 1375 Dishwasher

1 Answer

Won't drain and unit will not shut off

water will not go into my dishwasher any solutions

Nov 16, 2009 | Asko D1776 Stainless Steel Built-in...

1 Answer

Asko 1805 - inside light is on, none of the operation (front panel) lights turn on

Quite simple after all. If the main power button on the top left hand side of the door is pressed in (on). Whenever the door is openned their is a light in the DW which comes on like the fridge or oven.

Keeping the power button off turns the light off. For us this is good as we usually only close the door fully (catch catches) when we run the machine.This way we are not wasting electricity.

Nov 14, 2009 | Asko 24 in. 1805 Built-in Dishwasher

1 Answer

How to remove lower service panel on asko 1475

1) remove toe cover... lifts up
2) remove toe cover supports..pull back gray slide..then pull out cover supports.

3)remove 6 T20 screws ( 4 at the panel 2 that are hiddden .. or up under door...

4) rotate panel down and out...

hope it helps if NOT let me know more about your problem...

Sep 17, 2009 | Asko 24 in. D3112 Free-Standing Dishwasher

1 Answer

Asko 1475 dishwasher - won't wash. Circulation pump?

Check your drain. It is dual purpose. It not only drains but, it also recirculates the water doring the cycles.

Aug 10, 2009 | Asko Dishwashers

1 Answer

Blinking lights on Front Panel

I've finally tracked down the manual and it the fault code is as follows

"Indicates a fault in the heater or in the thermistor"

You can go into a fault tracing mode by pushing the "Rinse Hold" button five times within 15 seconds. The first, third, fifth and seventh lights will flash when in this mode and you can test the following parts by pressing the corresponding button. I'm going to try the heater test below and assume that if that works the fault must be with the Thermistor. The other tests could be useful for other faults.

User manual found here

Rinse Hold - tests detergent solenoid, detergent flaps open after about 60sec

Pots & Pans - tests Rinse Aid Solenoid, rinse aid will flow down door

Normal Wash - tests water inlet valve, water can be heard entering

Light Wash - tests ventilator solenoid, there will be a click followed by a rattling noise

Quick Wash - tests the heater, the element heats up, WARNING don’t touch element HOT

Temp - tests circulation pump, the pump starts

Dry - test outlet pump, the pump starts

Manual says to push 55 and 65 degree button to exit, I have no idea where those are so will probably just switch off at wall to reset.

Hope this helps someone. I rang ASKO and they said they didn’t know what the fault code meant so either they can’t read or their service sucks, probably a bit of both!

Feb 12, 2009 | Asko D1716 Built-in Dishwasher

1 Answer

Asko 1805 ALL lights flashing and no water coming out

High water level is often in the pan under the dishwasher.
  1. Unplug or turn off breaker.
  2. Remove kick panel.
  3. Remove water from pan.
  4. plugin/turn on breaker.
  5. watch for leaks.

May 30, 2008 | Asko 24 in. 1885 Built-in Dishwasher

1 Answer

Asko 1585 Dishwasher

do they flash lik all on one side then the other? Start a cycle, then open the door. Do the lights flash the same way when you open the door as when it stops? if soyou may have a door that needs to be adjusted so it closes better. when the cycle ends, is there any standing water in the bottom? if so you may have a poorly routed drain hose or a partial clog in it. Last, pull the bottom panels off and look inside the bottom of the dishwasher and see if there is standing water down there . If ther is you have aleak somewhere or a bad drain pump. You r only other choice is a bad pressure switch. If youve already adjusted the water fil to the proper level ( just up to the grey plastic housing that the lower wash arm sits on) tehre really aernt any more options. Hope this helps!

Aug 29, 2007 | Asko 24 in. 1585 Built-in Dishwasher

Not finding what you are looking for?
Dishwashers Logo

Related Topics:

678 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dishwashers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers


Level 3 Expert

4342 Answers

Are you a Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides