Question about Garden

1 Answer

Cord snaped - Garden

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 78 Answers

I am assuming you are refering to the Starter cord. All the plastic pieces must be removed. Then the blower housing . Inside you will see the starter wheel that winds the cord. You must wind the wheel until it is not possible to wind anymore,dont force it.Secure the wheel by passing a screwdriver thru the wheel and thru the housing. Position the hole in the wheel with the hole in the blower housing where the cord comes in.Pass the cord thru both holes and knot the end inside the wheel. Use a lighter to melt the cord just a little so it will not come unknoted. Pull the screwdriver from the housing and slowley let the spring re-wind the cord.If its a 5 or 6 hp briggs it take about 88 inches of new cord.Hope this helps.

Posted on Oct 29, 2009

  • Roger Geer Oct 29, 2009

    I am assuming you are refering to the Starter cord. All the plastic pieces must be removed. Then the blower housing . Inside you will see the starter wheel that winds the cord. You must wind the wheel until it is not possible to wind anymore,dont force it.Secure the wheel by passing a screwdriver thru the wheel and thru the housing. Position the hole in the wheel with the hole in the blower housing where the cord comes in.Pass the cord thru both holes and knot the end inside the wheel. Use a lighter to melt the cord just a little so it will not come unknoted. Pull the screwdriver from the housing and slowley let the spring re-wind the cord.If its a 5 or 6 hp briggs it take about 88 inches of new cord.Hope this helps.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 ml320 parking brake pedal will not release, hand release has no tension, alarm sounds continuously, but seems to drive fine


sound like the cable has snaped on some part of the system get the cable snaped the alarm will go off when the foot pedal is in the off position

Jan 21, 2014 | Mercedes-Benz Cars & Trucks

1 Answer

I can't open the hood of bmw car


has the cable that opens bonnet snaped have a look at the pully handle to see if the cable is still atached if its snaped its a garage job im afraid as you cannot get at the boot end without it being up a hight

Aug 26, 2012 | 2006 BMW 760Li

1 Answer

When I push the start button on my dryer it makes a clicking sound


hello there may be a few of things that could be wrong 1 check to see if the belt is ok it might have snaped if ok check the long pin on the inside of the door it might have snaped if ok the other cause could be the capacitor next to motor hope it helps

regards
shaun

May 26, 2011 | Dryers

1 Answer

The sprocket snaped as garagedoor was comming down how to repair it


You can get the part at any good door opener service company. The part number is 41C4220A and it comes with instructions.

May 11, 2010 | Sears Craftsman LiftMaster Chamberlain...

1 Answer

Snaps are blurr when we switch off the flash....


Not familiar with this Camera, but does it have an Auto Flash setting which you can set so the camera will decide if flash is needed or not try this if it is available and see if that helps.

Apr 04, 2010 | Olympus FE-270 Digital Camera

1 Answer

Think my sim card as snaped in side can you


Yes remove the battery cover.You will see a battery and a sim .You often need to remove the battery before getting at the sim.

Check if sim is damaged.If it is phone your supplier e.g orange,tmobile for a free replacement.

Hope it helped.

Dec 09, 2009 | Cell Phones

1 Answer

Ryobi trimmer not spinning, the motor runs fine, I think the friction clutch is worn.


Either the cintrifugal clutch is not engaging(if that model has one). Or the drive cable is snaped, or the rotary head drive lug is stripped. Pull off the drive head(where the nylon cord goes) & behind it is a flexable cable that transmits drive from the motor to the drive head(bobbin).pull it out and see if its broken.Check The rotary drive head lug,its on the top of the drive head (bobbin) you removed.
hope this helps
Regards Andrew Porrelli

Dec 05, 2009 | Ryobi 30 Cubic Centimeter Curved Shaft Gas...

2 Answers

How do i know if the cutch cable snaped?


If it snaped then you cannot change gears when the engine is running.

Jul 14, 2009 | 2005 Mazda RX-8

1 Answer

Snaped speaker wires


Solder the two ends together or sell the speaker to me wakesslide12@aol.com

Oct 25, 2007 | Kicker Solo-Baric L5 Car Subwoofer

Not finding what you are looking for?
Garden Logo

Related Topics:

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Garden Experts

Dennis Key
Dennis Key

Level 3 Expert

2478 Answers

john h

Level 3 Expert

12104 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Are you a Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...