Question about Sony Cyber-shot DSC-W55 Digital Camera

1 Answer

Broken lens on camera

The lens on my sony cyber shot wont extend out of the camera so the camera wont focus. where can I get if fixed near Killeen, TX and around how much do you think it would cost to get that replaced?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    One Above All:

    The expert with highest point at the last day of the past 12 weeks.

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

  • Sony Master
  • 102,366 Answers

Try the procedures in this tip.

Posted on Oct 05, 2012

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

jackboy
  • 2985 Answers

SOURCE: broken flashbuld on sony cyber-shot model dsc p-10

In short - no Repair as an economic proposition. If you don't need the flash live without it. If you need flash - buy the next camera

Posted on Jul 19, 2007

PEye2000
  • 10 Answers

SOURCE: Sony Cyber-Shot DSC-W30. The lens is in a "stuck" position

You have a bad lens, it prob. also says turn off and on again.

Posted on Mar 26, 2009

  • 586 Answers

SOURCE: SONY CYBER SHOT NOT WORKING

Hello samtx930, "turn off the power and on again" its a very commen problem and occurs when the lens block assembly start malfunctioning. Actually the slide motor not work properly and until the lens not come out completely the camera will not work, that's why the error message appears "Access" and then screen shows "turn off the power and on again". In this situation you have to replace lens block assembly.And the part No. is with description is given below: 1-788-363-11 OPTICS UNIT (ED13A) Thanks for using fixya.

Posted on Jun 14, 2009

  • 9 Answers

SOURCE: lens will not retract completly on sony cyber shot

I have experience this unfortunately the drive mechanics
motor and more so the gears are plastic when mine dropped it broke a tooth on the gear off the drive motor that drives the worm gear that extends and retracts the lens assembly. this sad to say but the units are not repairable and the assembly has to be replaced owen to the fact that it really is cheaper to replace the assembly than try and repair it.

Posted on Nov 28, 2009

Testimonial: "thank you. i had heard this before. after wiggling the lens it will go in and out now."

  • 411 Answers

SOURCE: Sony Cyber-shot DSC-W150. when powering on the

allienment with the mother board and also failure of the sensors of the lens unit,so contact sony service

Posted on Mar 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a sony cyber t70 camera and have an error code E:61:00 come up on screen and i cannot take a pictue please help me .. what solution can i find for this.. venkatesh


Sony claims that the E:61:00 error means "Difficult to adjust focus Inspect the lens block focus reset sensor". In my experience this means that the gears that extend and retract the lens are somehow jammed. This could easily happen if you hit something with the camera with your lens in extended (working) position.
You should try to:
- power off the camera
- place your thumb on the back of the camera and the fingers a few centimeters from the closed lens
- power on the camera, and with your fingers stop the movement of the lens forcing not to fully extend
- when the lens retracts or stops and then continues to extend, let it go

sometimes this would resolve the issue.
You may want to check this site:
http://www.fewin.com/sony/sony.htm
wich has similar trick for a different model from sony, but the error is the same.
Be careful not to force the lens too hard or you may worsen the issue.
Let me know if this helped, good luck

Feb 28, 2011 | Sony Cyber-shot DSC-T70 Digital Camera

2 Answers

E:61:00 on the display


E:61:00 means "Difficult to adjust focus Inspect the lens block focus reset sensor"
The simple solution to fix that error message was to the let the lens fully extend and give the lens a good whack. Possibly this error message for this means, that the auto focus motor was past the maximum set point.
goodluck
and do rate the solution if helped

Dec 06, 2010 | Sony Cyber-Shot DSC-P71 Digital Camera

2 Answers

The camera wil vibrate much like if your cell


Vibration in this model is problem with lens assembly.
Qualified camera tech can fix it either by repairing lens mechanism or replacing it.

Aug 12, 2009 | Sony Cyber-shot DSC-T70 Digital Camera

2 Answers

I DROPPED MY SONY CYBER-SHOT DSC-S730 WITH THE LENS OUT AND NOW IT WONT GO IN..


Lens mechanism is broken due to dropped. You need to replace lens assembly. If you know how to apart camera and replace lens assembly then let me know to guide you. Or take camera to local repair shop for fix.

Jan 09, 2009 | Sony Cyber-Shot DSC-S90 Digital Camera

1 Answer

Sony cyber-shot dsc-w50


Sounds like you have two problems, both which mean bad news. The clicking could be a broken gear in the lens unit or off track lens.
The colors may be caused from a bad ccd or sensor internally.

Aug 03, 2008 | Sony Cyber-shot DSC-W50 Digital Camera

1 Answer

My sony dsc h5 camera lens wont open/focus


This might be a problem with the lenses' mechanism... Maybe you hit the camera (having the lenses extended, eventually). You have to pay a visit to the local service.

And in the future, use the protection that came with the camera (the black cilinder). It protects the lenses and also offers you the possibility to mount the lens cap without having to switch off the camera.

Jul 27, 2008 | Sony Cyber-shot DSC-H5 Digital Camera

1 Answer

Camera is out of focus


Make sure its on auto focus instead of manual. Also make sure the lens is fully extended

May 12, 2008 | Canon PowerShot S500 IXUS 500 Digital...

Not finding what you are looking for?
Sony Cyber-shot  DSC-W55 Digital Camera Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Cameras Experts

kakima

Level 3 Expert

102366 Answers

james laughton
james laughton

Level 3 Expert

2119 Answers

JonSnell Electronic
JonSnell Electronic

Level 3 Expert

21397 Answers

Are you a Sony Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...