Won't go to menu

I am not sure what you mean? What will not even start up?-----------------------------------------------------------------------------------
2012 ELM327

Put another starter on but not the same brand,Autozone has them with life time warranty.

duplicate question.

hi
glad i served a long time with wisco and used drag raced for them at one time
sounds to me that your ignition is to far retarded
which means the ignition will spark closer to (TDC)
top dead center
some people advanced the ignition 3 deg to stop the engine from smoking when they did away with 4 star fuel
and gave us unleaded fuel
doing this the performance is great and fast acceleration
but it also make the engine run hotter than normal
unless you have up jetted the carbs
and fitted a non standard exhaust system
the whole idea is get the fuel/air mixture in and out as fast as possible

if you still have points
take your points cover off and adjust your points baseplate
undo the three screws that hold it in place
and just move it about 3 deg towards the rear of the engine
or may be you have a electronic ignition fitted
if so do the same thing
and advance the ignition 3 deg

hope this works for you

ride safe

The next time it won't start check the fuel pressure you should have 48-55 psi with key on and engine off.

it could very well be the starter solinoid mounted on fender under hood. most fords are setup this way. to test it -- You could use jumper cable to jump the two large studs on the solenoid together, which should make the starter crank the engine, assuming the engine can rotate freely. If jumping the solenoid works, then the solinoid is probably bad. have a good day !!

ounds as if the evaporator fan motor is not working. Listen for a fann inside ,if you herear it procdeed to 9nvistagat the defrost mode. Rem,ove the freezer back panel to look to see if it is frosted over. If so check the defrost strip, and advance the defrost timer until it clicks. watch to see it defrost if it does replace dedfrost timer.

Your oven tempertaure senser is bad (RTD)

Turn power off to range. Replace bake element. You can do it yourself.