How to connect mg06x to reciver - Audio Players & Recorders

NEWER connect A7 reciver box to A5 dome. A5 receiver box output voltage is 32VDC, and A7 receiver box output voltage is 40VDC. So, if you connect A5 dome to A7 reciver box, you will damage it.

Are you sure you have a good phone line connected? If so does it still have a dial tone? If so it's software issue. Youu'll need to contact the peaple for that software.

Please leave comment and review.

just try wih installing new battery in mouse and keyboard then press the connect button to sync with the reciver.

The proper sequence to eq just your CD player is, CD out to EQ in, EQ out to receiver in.

have you connected his sensor reciver there must be one more usb devise just press the connect button in mouse as well as in reciver to get syncronize.

1) Check to see if the screen says "EXT DECODER". If it does, press the EXT DECODER button again and this should fix the problem
2) Press input mode button until the display reads auto or digital. It may be set to analog.

I don't see why not. Use any record out or if you can rear pre amp out connect to the input on the bose unit.

sound source(cd or dvd)-----to equalizer input-------equalizer output------to marntz input(line in or tape in).

Blackberries have stronger security than most phones. They can usually only be used to send data to another phone. Or to connect to a blutooth headset.

You must check with the instalation gude for the wireless speaker to see if the connection to the reciver is a high impedence or low impedence... If its like most wireless set-ups its going to be a high impedence output from the reciver to the transmitter part of the speakers. That would be from the RCA jacks in the back of the reciver maked line out or tape out. If you want to use them for a specific speaker output , some recivers have an output jack that would be labeled center sperker out but would be an RCA type jack ect ect. If your reciver dosent have that you can in a higher end audio store get an adaptor to convert the speaker output to a high impedence, But I dont recomend that as some of the adaptors do cause excessive strain on the output section of the amp or reciver.. If you buy a good one though you should be fine.. You get what you pay for.. Good Luck