I just purchased a MFC-490CW all in one printer. After I set it up and loaded the paper it will not accept the paper. Constantly reads NO PAPER FED. I.ve done everything the manual says over and over and it still will nat accept the paper. HELP!!!!!!!!!!!!!!!

ITS COMPLAINT IS PRINTER MECHANISM OR SENCER PCB DAMAGED

You can get a manual here: http://www.retrevo.com/support/Brother-MFC-490CW-Multifunction-Printers-manual/id/22963bh245/t/2/
Hope this helps, if so please give me a thumbs up

Hello there
You may not see a paper jam.

This may work for you, it has worked for many here I given this advice so gave it a try it could work for you. Generally when this happens, something has fallen into the printer, or a piece of paper has been jammed in there.

First step, remove the ink cartridge, and turn the printer upside down and gently shake it, see if anything comes out.

If nothing goes, or you can't hear anything rattling around, get a piece of cardstock paper (60lb or heavier) and gently push this through the printer, to see if it will help push out what might be stuck in there.
And gave the rode that the ink slides on a good clean and maybe a bit oil on cloth and wipe the rod with it.

Please come back and just gave a vote, it will gave me some satisfaction to know am helping some one so I will keep on helping.
All The Best: Pineworks

YOu would need to remove jammed paper opening back cover.

Check the paper cassette and make sure the paper stop is flush up against the paper if it's not push it up against the paper and try again to print.

Only load photo paper do not mix it with plain paper, this will happen on all printers.

lower paper feeder is out of position. you have to open the printer and get to the lower paper tray feeder. push the plastic gear wheel and axe into position again.

According to page S-1 of the Specifications chapter of the Users Manual, the maximum paper weight that the MFC-3240C can tolerate is 80 g/m². This section of Wikipedia's article on Paper says that anything over 160 g/m² ranks as card stock, which includes your 180 g/m² matte paper. Card stock has choked just about every inkjet printer into which I've seen it fed, but even if that was not so, you are still using paper that is more than twice the "legal limit."

Hi , The incoming tray roller was sliding due to build up of dirt clean w/rubbing alcohol all rollers rotates manually.
Check also there might something stuck on the loading tray.