Tomato disease tomatoes are rotting out with a black spot on bottom as they begin to mature (still green). What is happening & how can we fix?

Anything can be replaced on it. Have patience and the new part ready.

Remove the little black plastic plug on the bottom of tank (has a metal spring around it), that is where it is leaking. Wrap Teflon (pipe tape) around it and the spring. Replace black plug. Not a permanent fix, but can help if you are on a bind. It worked for me.

see the next steps and follow with common sense: God bless you

If the noise is coming from the motor area it may be a broken fan blade, if it's broken replace it. If the noise is coming from the brush area then it may be a defective brushroller bearing or brushroller, if either is defective it needs to be replaced.
Inspect a) power cord b) outlet wall c) thermal FUSE very important.d) see any debris see diagram attached.

Hi,

Prepare Patties

1. Put minced scallions and chopped mushrooms in bowl.
2. Add red wine vinegar.
3. Add ground beef to bowl.
4. Mix everything together with your hands.
5. Flatten the beef into four patties that are 1/2-inch thick and 5 inches in diameter.

Cook Patties

1. Set stove-top grill or burner to medium-high.
2. Preheat nonstick frying pan. The pan is the correct temperature when a drop of water dances on its surface rather than sticking to it.
3. Place patties in the pan and cook for 2 to 3 minutes.
4. Flip patties and cook for another minute, and then add sliced cheese to the tops of patties if desired.
5. Cover pan and allow burgers to cook for a final 2 minutes. Cook 3 to 4 minutes for well-done burgers.
6. Remove hamburgers from pan and place in hamburger buns.
7. Add condiments and toppings such as ketchup, mustard, sliced tomatoes, lettuce, red onions and pickles.

Share some please! ü

Thank youfor visiting FixYa! We answer yourconcerns promptly for FREE. Please spare a few seconds toclick on YES button in return. Havea good one!

If it is not perfectly sharp, it will not peel a tomato regardless of technique. Also, it really depends on the tomato; a firm, not overly ripe tomato is your best bet. Blanching the tomato (briefly dipping it into boiling water and then quickly into cold water) helps release the skin for easier peeling as well. As to pressure, you can discover if that makes a difference by experimenting on your first good tomato. Farmerbear

cut it off. go to a hardware store and get a three prong plug which you can install onto the wire.

when you prepare the wire you will see a black wire, a white, and a green.

black goes to the brass screw, white goes to the dull screw and green goes to the green ground screw.

I returned it. I didn't see why I would have to pay you to fix a problem when It came broken. please take me off your list.

Thank you

Try blowing out the unit, particularly the bumper, with compressed air. Clean off the little windows on the underside of the bumper-- these are the cliff sensors. Then, most importantly, tap the bumper with your hand about half a dozen times to knock loose anything that's stuck. If the issue persists, give a call to customer support and let them know you're having the 9-beep errror.

white to motor terminal,black to other motor terminal,green is always ground to housing there is a small terminal tucked away its s small spot for the lights

http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=787057
Generic problem for all Vacuums
How on God's green earth
Posted by rickiman on July 15, 2008
How on God's green earth do I open the Fantom 12 amp to fix the beater brush belt?
Hello,
I would advise you to ALWAYS to FIRST UNPLUG YOUR VACUUM before beginning any service procedure. There are probably 2 ways to get @ the belt, usually there are screws, clips or levers on the bottom side of the bottom plate and once they are removed you should be able to get @ the belt, if not then the top cover should come off and then you should be able to get @ the belt. At this point you should be able to get @ the belt to change it. #2. you can always refer to your Fantom owner’s manual for additional information. So if you need further assistance, please feel free to contact your local vacuum cleaner dealer in your area or in the yellow pages, or contact the factory phone number or website to further assist you with your questions.
http://www.fantom.com/ Customer Tech Support 1-800-798-7398
Hours are Monday thru Saturday from 9:00 AM to 6:00 PM (EST)
Thanks, Don the Vac Man
Go Ahead. Use Us.