Looking for a free owners manual . Kenwood kdc-mp345u

Run Blue/White cable (P.CONT) from back of the radio to your amp for remote power

Below is the link for the manual, it shows the wiring.

Link:

The manual is here. Page 19 details the installation / wiring.

Good luck!

try checking your speaker wires and speakers for shorts or grounds. you may also have a bad output ic inside of the deck itself.

make sure none of your speakers or speaker wires are shorting out or are grounded.

You can get the mnanual on the link below.

http://www.usersmanualguide.com/kenwood/car_entertainment/kdc-ps900

Good Luch and please rate 4 thumbs up for the free answer

Check for Audio unit fuse under dash fuse box, bcz if that fuse is not there or blown off then circuit doesn't complete and u dont get power from ignition. The battery power only shows clock and display for few seconds and used to retain memory. So check for the fuse under dash fuse box.

1 kenwood KDC-129 manual as requested: http://www.kenwood-electronics.com.my/imanual/KDC-229.pdf

Go here angelfire ftp://inform.kenwoodusa.com/Manuals/kdc-s3007.pdf