Question about RCA D34W135D 34 in. TV/DVD Combo

2 Answers

Tv dont come on

Power button flashes green i dont get sound or pitcher

after a 12 hour power outage ,the power button comes on, then blinks, then cuts back picture,no sound.

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert whose answer got voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 37 Answers
Re: tv dont come on

Sounds like the typical power surge created by the outage has caused a power supply problem inside your TV. IF that is it, there not much you can do yourself.

Posted on Nov 07, 2007

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Master
  • 1,694 Answers
Re: tv dont come on

Try hard reset-leave ac cord unplugged for a while, then try again. Otherwise, I agree with chris5563.................T.

Posted on Nov 08, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Flashing green button

Where are you located? If you don't want this Sharp 35VX-H2000 anymore, I will take it, even if it's broken. Thanks.

Jun 29, 2010 | Sharp 35VX-H2000 35 in. TV/VCR Combo

1 Answer

Green light blinking

So the green light on the TV blinks, but the screen doesn't come on? The first thing I'd try (because it's free), is leaving the TV unplugged overnight. It may just need a discharge. If this does work, it'll take a couple minutes for the TV to come on afterwards. You may also want to try plugging it into a different outlet just in case the power level is wrong at that outlet. Beyond that, it could be the power supply or the main picture tube. Try what I suggested above, and if it doesn't work we'll look into it further.

Sep 02, 2007 | Quasar VV-2001 20 in. Combo

1 Answer

I have a Magnavox TV/DVD and i recently had a power outage. The power came back on and turned on the TV and the color of the TV screen is a purple or green tint. There is only a tiny circle about 1 inch in...

Remove the the plug from the wall socket(power) plug it back after five minutes. If the power outage was caused by lightning, then it is most likely static on the screen.


Sep 12, 2009 | Combination Televisions

1 Answer

No power

My tv worked at 1:30 am, one day and the next morning at 8:00am it would not come on. The power button comes on and blinks and the it goes off. can you help me?

Mar 17, 2009 | RCA T19408 19 in. TV/VCR Combo

1 Answer

RCA D52W135D HDtv inop

Are you prepared to spend $400 maybe more to fix it? The cat pee isn't the problem. It is either the SSB or power supply.

Jan 25, 2009 | RCA D52W135D 52 in. TV/DVD Combo

2 Answers

Blinking light front of TV

You need to set the clock. The timer is confused if it dose not know the time.

Jan 19, 2009 | Quasar VV-2002 20 in. TV/VCR Combo

2 Answers

TV wont come on

the picture tube is most likely not out. but there is a problem in the high voltage transformer part of the set( this is what fires up the picture tube). a problem like that can be just as expensive as a new picture tube. if it's not still in warranty it would be cost prohibitive to repair.

May 02, 2008 | Combination Televisions

1 Answer

JVC TV-13142 13 in. TV/VCR combo: On timer light blinking

The TV is on protect mode.

Try first leaving the TV power cord unplugged for some times, let say one hour or so.

Also ensure that the fault is not coming from a faulty receiver box sending bad signal, check if you get same problem with no receiver box or dvd connected.

If that does not work, and you keep having a flashing led on front of the TV, and tv turning off by itself after a while, that indicates a fault condition.

The flashing light indicates a diagnostic state called protection.
When the TV goes on protection there are only two possible reasons.

1The internal circuits are jammed because of electrostatic charges accumulating on capacitors, or because of a wrong voltage read by the main chip on your monitor controller board. this started the protection circuit.

2 The protection circuit detected a wrong voltage or abroken contact, identified an internal fault and kicked in , startingthe flashing light.

If you are in situation one, then theTV will reset just unplugging power cord for one or two hours,sometimes even minutes.

If you are in situation 2 , then there is an internal fault.

Common faults that can occur are a blown capacitor on power board, a convergence IC has blown, or a fault on Digital board.

Check also the video cable or any external connection cable, if the cable is shorting, or the connector is bad, you can get same flashing state because of the video cable.

If under warranty contact the manufacturer ringing the number on the user manual

If you want to repair at your own expenses, just locate any good qualified repairer.

Dec 16, 2007 | JVC TV-13142 13 in. TV/VCR Combo

2 Answers

On/off button flashes green, unit will not turn on manually or with remote


Sep 25, 2006 | RCA T19064 19 in. Combo

1 Answer

TV won't turn on.

Try pressing & holding the power button ON THE REMOTE for 6 to 10 seconds. the unit sould come back on. Info should be at the bottom of page 10 of your owners manual for "front panel block"

Sep 06, 2006 | GE 19TVR62 19 in. TV/VCR Combo

Not finding what you are looking for?
RCA D34W135D 34 in. TV/DVD Combo Logo

Related Topics:

273 people viewed this question

Ask a Question

Usually answered in minutes!

Top RCA Combination Televisions Experts

matt martin
matt martin

Level 3 Expert

1187 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

Cindy Wells

Level 3 Expert

4720 Answers

Are you a RCA Combination Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides