Question about Denon AVR-3300 Receiver

1 Answer

Willnot power up. - Denon AVR-3300 Receiver

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 2,071 Answers

Just open the unit and then check the fuses,if the fuses ok. Then check the filter capacitor in power supply if its ok ,then check the regulator,if its ok. Then check the four transistors output stage of the amplifier. Maybe there is the problem there.

Good luck..

Dont forget to rate:

Posted on Jun 29, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

No lights on controls but power at theplug willnot start ?

? power at the plug, so power at the socket, but not in unit. check unit fuse in plug, check for fuses on unit, usually at back near to power inlet

Aug 13, 2014 | LG LD301EL Dehumidifier

1 Answer

New pto clutch willnot engage gets hot

First off I would check for power and ground at the connector. Not knowing what kind of unit you have I have to go with the most common, or what I see the most of.. The PTO switches are bad to short out on some models and can cause all kinds of issues. I hope this is not a case of replacing the clutch when the switch was the problem.. Good luck..

Apr 13, 2014 | Toro Garden

1 Answer

Tv willnot power up

A "no power up" condition is either caused by a faulty power supply or main board. With the set plugged in, does the power indicator light come one?

Mar 16, 2014 | Samsung Televison & Video

1 Answer

Cyberhome ch-dvd 300 player willnot come out of standby and willnot reset after holding reset for 30 sec

Possible failure of the processor. You can shut down, power off the unit completely. Allow time - few hours - for the voltage to drain off thereby resetting any error voltage on the processor. Now repeat the resetting when you power and if there is no response the chances of the processor or motherboard having errors/damaged components are high which will require a voltage/signal/logic trace in the processor

Oct 03, 2011 | Cyberhome CH-DVD 300 DVD Player

1 Answer

My wii the power will not come on

Your best bet is to ask your friend to try his power cord to see if its the power adapter or the wii itself.

Jan 28, 2010 | Video Game Consoles & Games

1 Answer

Willnot boot up will not go past toshiba start page ,three horizontal white bands at bottem of screen willnot play any music /any saved documents

try botting into safe mode by taping f8 assune as the computer power is on and then select safe mode with networking and go to and check for virusses

Jan 17, 2010 | Toshiba Computers & Internet

2 Answers

Laptop willnot power up. I have checked the ac

It could be the battery which is at fault, take the battery out and try to boot it on AC power only.
Please post back with the results.

Good luck.

Jul 29, 2009 | Gateway MX6920 Notebook

1 Answer

Lcd tv willnot turn on

mainboard damaged.

replace the mainboard and that should solve your problem.

May 11, 2009 | Televison & Video

1 Answer

The tv willnot power up .the light keeps flashing and huming

Check the horizontal output transistor (H.O.T.) next to the flyback transformer. If it is shorted, the switching supply won't turn on.

Dec 05, 2008 | Samsung HCP4252W 42" Rear Projection...

1 Answer

Condensing unit willnot turn off

First check for power, to the contactor ,if no power then backtrack for power, If got power and nothing happens, the its the capicator out due to power surge, see if the capacitor is bulged on the top or bottom! Thank-you-very-much!

Aug 26, 2008 | Heating & Cooling

Not finding what you are looking for?
Denon AVR-3300 Receiver Logo

Related Topics:

324 people viewed this question

Ask a Question

Usually answered in minutes!

Top Denon Audio Players & Recorders Experts


Level 3 Expert

5455 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

The Knight
The Knight

Level 3 Expert

75462 Answers

Are you a Denon Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides