Question about Lasko 2554 WIND CURVE Fan

2 Answers

Cleaning my 2554

How do I get my 2554 Wind Curve apart to clean it??

Posted by on


2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 90 Answers

There are 20 screws to take apart the fan.
but try this
something to wedge the blade and blow out the fan. it will work jus the same

Posted on Aug 01, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Our 2554 c fan keeps shutting down after 30 min or so. we set the timer and it shuts down wel before it should. Any ideas to what is cousing this problem.

Posted on Jul 08, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where can I find a motor for a lasko FAN model 2554. Motor number is Decomin 2033014 120V 0.45A Thanks.

No guarantee they would see one, but you could start looking here and see what they have to say.....

Sep 17, 2010 | Lasko 2554 42" Wind Curve Fan with remote...

1 Answer

My lasko mod 2554 fan powers up but the fan will not work. The fan oscilates and the ionizer and timer lights all work.

It is possible that the main capacitor is faulty and so the coils is not enerrgised to start.
So check winding and check the capacitor for open.
Test capacitor by charging both the pins to mains voltage and shorting the pins to see if charge is retained.If retained the capacitor is good, if not replace.

Sep 08, 2010 | Lasko 2554 Wind Curve Tower Fan with Fresh...

2 Answers

Its not a problem. How do you clean this fan. There is alot of dust inside of the front grid. Is there a special way this front grid can be removed for cleaning? Thanks.

My experience is that the best way is to use the canned air like you would clean a computer keyboard with...trying to remove the grille will result in broken tabs and then you have to tape it back on...


Aug 29, 2010 | Lasko 2554 WIND CURVE Fan

2 Answers

Fan will not run,oscillater still works

Motor probably went bad. I just fixed one of these today and noticed it had a sealed motor. You can't rebuild them. but try spraying wd-40 on the motor shaft then spin the shaft/blower so it works in then let it dry for 30 minutes.

Aug 12, 2010 | Lasko 2554 WIND CURVE Fan

1 Answer

My lasko wind curve 2554 has suddenly developed a steady ticking noise whether it's oscillating or not. I've taken it apart & nothing was caught in the blades. Blew it out & oiled a little at the...

It's probably the motor. I doubt there's anything that can be done besides just live with it if it isn't too loud. If you were a tech guru, you might be able to take the motor apart and do something but otherwise, for us mere mortals, when something this serious goes wrong with something this inexpensive, it's either live with it or junk it and buy a new one.

Jul 10, 2010 | Lasko 2554 WIND CURVE Fan

1 Answer

How do you clean the ionizer in a lasko wind curve

You have to take the fan apart. They didn't design it with the convenience of the customer who likes to keep things clean in mind, so you have to get out a bunch of screwdrivers and stuff and roll around on the ground and fight with it until you get it apart. I posted a lengthy post on how to get this model apart, as I just did mine yesterday. Just look for my name on the Lasko models like this one. But be careful and don't try it if you don't think you can pull it off without getting hurt.

Jun 11, 2010 | Lasko 42" Wind Curve Fresh Air Ionizer Fan...

2 Answers

How do you clean a tower fan?

How do we clean the Lasko 2554 tower fan filter please some one help email me at

May 05, 2010 | Lasko 2554 WIND CURVE Fan

1 Answer

Are there any points to be oiled on the Wind Curve fan; how much; how often?

you need to dismantle the fan.
there are 4 screws under the base
and 16 to the back
top and bottom of the blade is to be oiled
as often as it get dirty.

Aug 01, 2009 | Lasko 2554 WIND CURVE Fan

1 Answer

Where can I find a motor for a lasko FAN model 2554C. Motore number is Decomin 2033014 120V 0.45A Thanks

call up the comp! or if you brought it less than a year they have to replace it the catch is the recipt!

May 09, 2009 | Lasko 2554 42" Wind Curve Fan with remote...

1 Answer



Apr 05, 2009 | Lasko 2554 WIND CURVE Fan

Not finding what you are looking for?
Lasko 2554 WIND CURVE Fan Logo

Related Topics:

862 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lasko Dryers Experts

Craig Butler
Craig Butler

Level 3 Expert

1723 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18425 Answers

Jay Finke
Jay Finke

Level 3 Expert

1384 Answers

Are you a Lasko Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides